Daewoo Forkilt Operation & Maintenance Manual page 87

After Starting the Engine
Observe all indicator lights and gauges frequently
during operation, to make sure all systems are
working properly. The entire indicator lights will
come ON with the ignition switch in the ON position
before the engine is started.
Diesel
1
3
LPG/GAS
1
8
1. The engine oil pressure indicator light (1), will
not come ON with the engine running, unless
there is low or no oil pressure. Stop the engine
immediately, if the light comes ON.
6
2
5
4
ILOO001P
2
5 6
IB1O003L
2. The alternator indicator light (2), should not
come ON
alternator is not charging if the light comes ON
with the engine running.
3. The G424/430E
Indicator Light) will not come ON with the
engine running, unless the fault or faults are
stared in the memory of the engine control
module(ECM). Stop the engine and check the
electric engine control system if the light comes
ON. Refer G424E/G430E Engines of this
7
section.
4. The diesel engine water in fuel filter indicator
light(4), will not come ON with the engine
running, unless water in fuel filter exceeds
100cc. Stop the engine immediately and drain
the water if the light comes ON.
5. Observe the fuel level gauge (5) for fuel level in
the tank.
6. The engine coolant temperature gauge pointer
(6) will be in the green band with the engine
running, unless the coolant temperature is
excessive.
7 7. The transmission oil temperature gauge pointer
(7) will be in the green band with the engine
running, unless the oil temperature is excessive.
8. Observe the hour meter to make sure it is
operating properly.
If the excessive valve noise
occurs (G424 and G424E Engine
Only)
In normal case, the recommended engine oil for
G424 engine is SAE 10W30.
But, if the excessive valve noise occurs up to five
minutes after a cold start and if the maximum
ambient temperature is lower than 10 C (50 F), it is
recommended to change engine oil to SAE 5W30
for that application.
-85-
Operation Section
during normal operation.
engine MIL(Malfunction
The