Honar RC300 Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Original Instruction

Instruction manual

RC300

P2M004STD-VER.1.1

Table of Contents

Need help?

Do you have a question about the RC300 and is the answer not in the manual?

Questions and answers

Summary of Contents for Honar RC300

Page 1 Original Instruction Instruction manual RC300 P2M004STD-VER.1.1...
Page 2: Table Of Contents
ORIGINAL INSTRUCTION Table of Contents Introduction............................... .
Page 3: Safety Tips
ORIGINAL INSTRUCTION Safety Tips 1. The appliance is intended for commercial use or similar use (etc. to be used by a layman in shops). 2. DO NOT use the appliance outside. 3. DO NOT attempt to service the item yourself. 4.
Page 4 ORIGINAL INSTRUCTION Safety Tips 19. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety (IEC603365-1).
Page 5: Installation: Location: Electrical
ORIGINAL INSTRUCTION Installation: Location: Electrical The cabinet is intended for connection to an alternating current. The connection voltage (V) and frequency (Hz) are shown on the name plate in the cabinet. The power connection is made using a three-pin plug to a wall socket. Any requirement for earthing from the local power supply must be met.
Page 6: Installation: Location: Electrical
4. Slim cooler RC300: By placing the cabinet in an environment with high air humidity, it may be necessary to acquire extra equipment for evaporation of the drip water in the pan near the compressor.
Page 7: Cabinet And Controller Operation Instruction
ORIGINAL INSTRUCTION Cabinet and Controller Operation Instruction Storing food stuffs: To get the best results from your appliance, please follow these instructions: 1: Only store foodstuffs in the appliance when it has reached the correct operating temperature. 2: Always close the door. when hot in use and appliance is switched on. The appliance has fan operating door switches and WILL NOT cool when the door is open.
Page 8 ORIGINAL INSTRUCTION Cabinet and Controller Operation Instruction • This appliance is equipped with durable, long lasting, power saving LED lights in the cabinet. • The lighting may be switched on and off, using the switch. (As shown in Figure 3) Figure2 Figure3 Figure1...
Page 9: Door Gasket Removal And Replacement
ORIGINAL INSTRUCTION Door Gasket Removal And Replacement Fitting of the Shelves • Fit the shelf support clips onto the shelf support strips, making sure that the four clips for each shelf are of the same height and that they are securely engaged on the support strip. •...
Page 10: Cabinet Breakdown
ORIGINAL INSTRUCTION Cabinet Breakdown Mechanical thermostat OPTIONAL 2°LED 32 31 30 29 Number Part Name Qty. Number Part Name Qty. Assembled Body Bottom hinge pivot insert Evaporator spacer Bottom hinge pivot Evaporator Bottom hinge Bottom shelf Door gasket Shelf Condenser Rail guide Condenser fan blade Shelf support...
Page 11 ORIGINAL INSTRUCTION Cabinet Breakdown Electronic thermostat OPTIONAL 2°LED 32 31 30 29 Number Part Name Qty. Number Part Name Qty. Condenser fan blade Assembled Body Condenser fan Evaporator spacer Condenser fan support Evaporator One-way roller Bottom shelf Water tray plate Shelf Condenser water tray Rail guide...
Page 12: General Maintenance
ORIGINAL INSTRUCTION General Maintenance Before cleaning, switch off the cabinet and disconnect from the mains. The cabinet should be kept clean using a mild soap solution. Do not use abrasive cleansers. The plastic parts cannot withstand boiling water(max. temperature +85 °C). When regular cleaning is performed, be sure to wipe clean the rubber door gasket to ensure any sticky substances are removed that would otherwise damage the gasket.
Page 13: Technical Data
EVAPORATOR FAN CONDENSER FAN COMPRESSOR OVERLOAD RELAY TEMPERATURE PROBE TRANSFORMER 1 TRANSFORMER 2 LED LIGHT 1 LED LIGHT 2 RC300 MECHANICAL VERSION POWER PLUG LIGHT SWITCH THERMOSTAT EVAPORATOR FAN CONDENSER FAN COMPRESSOR OVERLOAD RELAY ROOM TEMPERATURE PROBE CONDENSER TEMPERATURE PROBE...
Page 14: General Trouble Shooting
ORIGINAL INSTRUCTION General Trouble Shooting If your Refrigerator, Freezer appliance develop a fault, please check the following table. Fault Probable Cause Action The appliance is not working The unit is not switched on Check that the unit is plugged in correctly and switched on Plug and/or lead are damaged Call our agent or qualified...
Page 15: Disposal
ORIGINAL INSTRUCTION Disposal Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncotrolled waste disposal, recycle it responsibly to promote the sustainable re-use of material resources. To return your used device, please use collection systems or contact the retailer where the product was purchased.
Page 16 17~18 19~20 21~22 Montage des étagères/grilles 24~25 ATTENTION: Risque d'incendie! INFLAMMABLE RÉFRIGÉRANT R600a...
Page 20 SLIM COOLER RC300...
Page 21: Thermostat 1
Réglage et contrôle de la température - Lorsque vous ouvrez la porte à l'intérieur du cabinet, dans la direction supérieure avant vous pouvez trouver le bouton de commande du thermostat (comme montré dans la figure, N ° 1) - Pour réduire la température au sein du cabinet, tourner le bouton du thermostat dans le sens horaire, tout en faisant tourner le thermostat anti-horaire, va augmenter la température au sein du cabinet et enfin l'éteindre.
Page 22 Cet appareil est équipé dans l'armoire de feux à LED avec longue durée de vie pour • économiser l'énergie. L'éclairage peut être allumé et éteint, en utilisant l'interrupteur (au-dessus du bouton du • thermostat) Figure2 Figure3 Figure1...
Page 23 Montage des étagères/grilles • Monter les clips de support sur les bandes de support d'étagère, se assurer que les 4 clips pour chaque étagère ont été positionnées dans la même hauteur et en sécurité sur la bande de support • Déballer soigneusement chaque gille, pour éviter d'endommager le revêtement de protection. •...
Page 24 Mechanical thermostat OPTIONAL 2°LED 32 31 30 29 Number Part Name Qty. Number Part Name Qty.
Page 25 Electronic thermostat OPTIONAL 2°LED 32 31 30 29 Number Part Name Qty. Number Part Name Qty.
Page 27: Light
280L 30Kg 478x775x1980 43 db LIGHT SWITCH TRANSFORMER 1 TRANSFORMER 2 LED LAMPE 1 LED LAMPE 2 RC300 MECHANICAL VERSION LIGHT SWITCH THERMOSTAT ROOM TEMPERATURE PROBE CONDENSER TEMPERATURE PROBE TRANSFORMER 1 TRANSFORMER 2 LED LAMPE 1 LED LAMPE 2 RC300 ELECTRONIC VERSION...