HoMedics MDA100-EU Instruction Manual page 4

INSTRUCTIONS FOR USE:
AREA
Cheeks
MAX LEVEL 3
(Level 3)
ROUTINE
Charging the battery
When the level indictor LED flashes red, the product needs charging. Connect the
charging base to the mains using the USB power lead and the appropriate plug.
Place the handle in the charging base and press down firmly. The LED lights will
flash to indicate that charging is taking place. When charging is complete all the
lights will stay on. It takes 4 hours for a full charge, which will provide 90-120
minutes use, dependent on power levels used.
Filter Fitting and Replacement
For correct operation it is very important that a new black wool filter is fitted
before each use of the device. The filter collects dead skin cells and should be
disposed of after use and then replaced. Using the device without a filter will
allow debris and dead skin cells to enter the motor, shortening the life of the
product and invalidating the guarantee. (Fig.1)
What to Expect
Regular microdermabrasion treatments can both restore and maintain a
youthful appearance to the skin. We advise starting slowly with just one or two
treatments a week, then building up to treatments every other day if desired.
Around Lips & Chin Around Eyes
2
(Level 1)
(Level 2)
NOTE: Avoid the sensitive
areas immediately above
and below the eye.
During use you should feel a gentle suction effect as the tip moves across the skin
and some people may also notice the slight coarseness of the diamond tip.
Depending on your skin type, you may experience some reddening or increased
sensitivity after treatment. This is perfectly normal and usually subsides within
a few hours. You may wish to consider this and make your first treatment at the
end of the day rather than just before going out.
Adverse reactions are rare, but if skin becomes unduly inflamed or irritated, stop
using the device immediately.
Facial Treatment Routine
• Wash and dry your face
• Remove the handle from the charging base and fit your choice of diamond
tip with a new black wool filter.
• Press and hold the power button for 2 seconds to turn the unit on. Press
again as required to increase the power level, as indicated by the LEDs. It is
recommended to start on level 1 for the first treatment and to progress to a
higher level if comfortable. See also MAX recommended levels in the above
diagrams
4
Forehead
1 4
(Level 4)
(Fig.1)
Nose
4
(Level 4)