Settings
In any mode, touch
【
】
icon can switch Settings interface.
Touch 【
】 icon can set function's switch; up and down sliding can enter next page.
◆Brightness
】 icon can adjust screen's brightness.
Left and right sliding【
◆ Factory settings
】 icon can show number keyboard, input"0000" , then click【 √ 】 icon, can go to
Touch【
factory setting menu. Then can set radio region/ starting logo/ function icon/etc.
◆ Calibration
setting
】 icon can show number keyboard, then click【
Touch【
◆Serial number& Version
Touch【
】 icon can enter and check Serial number& Version.
As some units' Serial number& Version is different as menu showed, pls refer this to real units
◆Language setting
Touch【
】 icon can enter Language setting interface, set the language needed.
◆Restore factory settings
】 icon can show "Confirm to Reset Factory
Touch【
After this operation, all unit's setting information will restore to the default mode.
√
】 icon can start correction.
",click【√ 】icon can restore.
11
SWC setting
① Connect the SWC harness' positive& negative electrode from original car with car unit's harness
positive and negative electrode.
② In setting menu, touch 【
】icon enter SWC setting interface.
③
Click 【
】the function button that need to be set, as below picture:
④When the set function button is lighted, long press the corresponding button on car SWC,
K2 icon will be lighted after set successfully. as below picture
】icon can save setting.
⑤
Touch【
】icon can reset.
Touch【
If need reset function, click【
】icon, then the functions set before will be deleted.Then
repeat the above steps can reset corresponding functions.
12