Advertisement
TROUBLESHOOTING
• INDICATOR LIGHT CONTINUES TO FLASH RED, DOES NOT FLASH BLUE
Solution 1: Check whether MiniPak is placed upright and whether both sides of MiniPak has sufficient access
to air.
Solution 2: Check whether purge outlet is covered.
Solution 3: Remove HYDROSTIK from MiniPak, wait for red light to come off, and insert HYDROSTIK again.
If it does not work, the HYDROSTIK might be empty, replace it with a full one.
• INDICATOR LIGHT DOES NOT TURN ON AFTER HYDROSTIK IS CONNECTED
Solution 1: Make sure HYDROSTIK is connected tightly to the MiniPak.
Solution 2: Use a full HYDROSTIK.
Solution 3: You may have left HYDROSTIK connected to the MiniPak without using the system for long time,
which might have damaged the fuel cell.
• WATER DROPLETS START TO FORM UNDER THE MINIPAK
Solution: Position the MiniPak upright during operation so both its air vents can access ambient air.
• MY DEVICE DOES NOT CHARGE WHILE THE BLUE INDICATOR LIGHT IS ON
Solution 1: Check all the connections to make sure MiniPak is operating appropriately.
Solution 2: Some devices, like iPhone 4 or iPad, sometimes may show "Charging is not supported with this
accessory", however, as long as the blue light is ON, MiniPak is still charging but at a slower speed.
Solution 3: Please also try disconnect and reconnect your device with MiniPak, the error message may go
away after that and your device will be charged at normal speed.
• THE MINIPAK SURFACE IS WARM
Solution: The fuel cell will heat up during operation, this is normal.
7
FCHP-02_MiniPak_UM_V2.5_EN
Advertisement
