Summary of Contents for Lutron Electronics DT-2249A
Page 1
Digital synthesis, high reliability, Xenon tube STROBOSCOPE Model : DT-2249A Your purchase of this D i g i t a l s y n t h e s i s Stroboscope marks step forward for you into field precision measurement.
Page 2
Warning ! Do not look directly at strobe/reflector. Light pulses at the frequency greater than 5 Hz may cause photosensitive epilepsy in some individuals if directly viewed. A feature of the instrument is to make moving objects appear to be stationary. Precaution should therefore be taken to ensure that there is no physical contact made with objects being viewed.
Page 3
Caution Symbol Caution : * Risk of electric shock ! Caution : * Do not use fingers or any tool to touch the FLASH TUBE. * The instrument contains no user serviceable parts and should not be opened by the user. * Repair or after service should be done by a qualified technician only.
1. FEATURES * The Digital Stroboscope is used the microprocessor circuit design, high accuracy, digital readout, light duty, that is ideal for inspecting and measuring the speed of moving gears, fans, centrifuges, pumps, motors and other equipment used in general industrial maintenance, production, quality control, laboratories and as well as for schools and colleges for demonstrating strobe action.
2. SPECIFICATIONS 2-1 General Specification Display 14 mm(0.56") LED, 5 digits. Flash adjust 60 to 30,000 RPM/FPM. * RPM : round per minute. range * FPM : flash per minute. Resolution 0.1 RPM : < 1,000 RPM. 1 RPM : 1,000 RPM ≧...
Page 7
Signal The signal adjusting circuit is used the Stability digital synthesis circuit, the output signal will existing high stability and not change. Power Less than 30 Watt. Consumption Operating Temp. 0 to 50 (32 to 122 ℃ ℉ Operating Less than 80% R.H. Humidity Dimension 21 x 12 x 12 cm (8.3 x 4.8 x 4.8 inch).
5)Do not use fingers or any tool to touch the " Xenon tube " ( 3-7, Fig. 1 ) Caution : * Do not use fingers or any tool to touch the " Xenon tube " * Risk of electric shock ! 4-2 Checking Speed (RPM/FPM) 1)Power off the installation to be measured, make a "...
Page 12
4)Setting value by " Digital adjusting knob " Rotate " Digital adjusting knob " ( 3-2, Fig. 1 ) to adjust the exact display value. Turn the knob to clockwise direction will increase the display value. Turn the knob to counter-clockwise direction will decrease the display value.
5)The Stroboscope will also stop motion at 2:1, 3:1, 4:1 et., this is normally referred to as harmonics. To ensure unison, turn the dial until two images appear - this will double the actual speed. Then lower the flashing rate until a single and stationary image appears - this is the actual true speed.