Digital Baby Monitor WIRELESS 2.4GHz DIGITAL BABY MONITOR USER MANUAL Congratulations You have just purchased a qualified Wireless 2.4GHz Digital Baby Monitor. Please read this instruction carefully before using the product. Keep these instructions for future reference. Table of Contents Parts and Quick Reference Safety Precautions Battery Installation...
Page 2
Baby Unit: 1. Antenna 2. Night Vision Infrared LED‘s 3. Microphone 4. Camera 5. Camera Rotation Handle 6. Power Indicator 7. Link Key 8. On/Off Switch 9. AC Adaptor Jack Parent Unit: 1. Antenna 2. Power Indicator 3. Speaker 4. Control Key(/ / Menu key) 5.
Safety Precautions When using this unit, basic Safety Precautions should always be followed to reduce the risk of fire, electric shock, or personal injury. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on this unit or mentioned in this operation instruction. 3.
2. Open the battery door. 3. Insert 3 AA alkaline batteries into the Baby unit according to the polarity shown in the battery compartment. 4. Replace the battery door at the inclined angle, press down the screw and screw it up again. Baby Unit 5.
change the battery or charge the assigned rechargeable batteries. Battery Status Charging the Batteries (only for Parent Unit) Please charge the rechargeable batteries for first time usage. 1. Use only the supplied AC adaptor for charging the assigned rechargeable batteries. 2.
3. Check the sound reception on speaker of the Parent Unit and adjust the appropriate volume. (To adjust volume, please see the ―Functions Setup‖ section ) Functions Setup A. Baby Monitor Functions Setup A1. Parent Unit Screen 1. Signal 2. Parent unit Battery A2.
Page 7
3. Outdoor Mode 1> Enter into main menu by pressing ―MENU‖ key, press ――or―‖ key to select Outdoor Mode option, then press MENU key to confirm and enter into Outdoor Mode menu. 2> Press / key to turn on or turn off Outdoor Mode. Press ―‖ presenting ‗1‘ which means the Outdoor mode is turned on.
If the video of the mother unit is blurred, adjust the lens switch of the baby unit until the video reaches the best image quality. (See picture below) Location and Set Up You can position and adjust the Baby Unit in a variety of ways to provide the best view of your baby. To optimize the performance, position the monitor unit 3 ft (1m) away from the baby.
Trouble Shooting Problem Possible Cause Solution - Slide the ON/OFF switch to the ―ON‖ Power indicator - Unit is not turned on. LED does not light position - Power is switched off - Make sure that power outlet is turned on. - Batteries may be used up - Replace new batteries - AC Adaptor not properly...
- Baby unit is turned off. - Turn on the Baby unit. - The units are detected out of - Ensure both units are in the communication range communication range. - Baby unit is in low power. - Replace new batteries or operated by the supplied adaptor.