Advertisement
Product Overview
This Wireless speaker system is designed to transmit audio from TV to a
speaker across the room resulting in a more comfortable listening level. This
system includes a transmitter (to be placed above the TV) and a speaker (to be
placed above the bed)
IMPORTANT--This speaker system works by IR and requires direct line of
sight from the transmitter to the speaker. To work properly, there cannot be
any obstructions between the transmitter and speaker.
6' - 7'
op tim um
6' - 7'
he ig ht
op tim um
he ig ht
n te d
e r m o u
R e ce iv
T V o n
n te d
a b o ve
e r m o u
te w a ll
R e ce iv
o p p o si
T V o n
ab o ve
te w al l
o p p o si
The transmitter must be mounted a minimum of 5 feet above the floor with 6-7
feet being optimal. The speaker must be mounted above the bed and at least 5
feet above the floor with 6-7 feet being optimal.
WARNING--This product is placed above the bed and must be properly in-
stalled. Failure to install properly could result in serious injury. This product
and included hardware were designed to be installed on drywall. If you are
mounting to another type of wall, please contact RCA Commercial for specific
guidance.
6 ' - 7 '
R e ce iv
o p ti m u
e r m o u
m
n te d
6 ' - 7 '
ab o ve
h e ig h t
T V o n
R e ce iv
o p ti m u
o p p o si
e r m o u
m
te w al l
n te d
ab o ve
h e ig h t
T V o n
o p p o si
te w al l
Mounting Instructions
Install Wall Bracket and Speaker
Step 1-- Install Wall Bracket to wall above bed (at least 5 feet up from the
floor) using supplied snap toggle hardware on the left and right "keyholes"
(see below). The 3 middle holes can be used for ADDITIONAL stability but
require additional hardware that is not included.
Step 2-- After wall bracket is securely mounted, attach speaker to wall bracket
using supplied thumb screws.
NOTE: Angle of speaker is adjustable..
Step 3-- Plug AC Adapter into speaker and wall outlet or insert lantern battery
behind speaker grille.
Step 4-- Select "channel" on back of speaker to match "channel" on transmitter.
NOTE: Each speaker and transmitter has 2 channel selections either
channel 1/2 or channel 3/4 depending on the model. You can use up to 4
wireless devices per room, but you cannot use the same channel more than
once per room.
Using the Snap Toggle hardware:
Drill a 1/2" hole. Hold metal channel flat alongside plastic straps and slide
channel through hole. Minimum clearance behind wall: 1-7/8".
Hold ends of straps between thumb and forefinger and pull toward you until
channel rests flush behind wall. Slide plastic cap along straps with other hand
until flange of cap is flush with wall.
Snap straps at wall by pushing side to side, snapping off straps level with
flange of cap.
Place item over flange. Insert bolt through item and tighten until flush against
item, then stop.
Use machine screw or bolt to match thread in channel: BA (3/16"-24), BB
(1/4"-20), BM5 (M5), and BM6 (M6).
Bolt length = item thickness + wall or ceiling thickness + 1/2"
Advertisement
