Ednet 91610 Manual

A4 size

Advertisement

The laminator is only suitable for laminating documents. Any other use or modification shall
be deemed to be improper and involves substantial risk of accidents.

Important advice about safety

1. Read through these operating instructions carefully and completely before using the
machine for the first time.
2. Only put the machine on a flat and dry surface. It must be freely accessible from all sides.
It is not recommended to use an extension cable!
3. Do not open or repair the laminating machine yourself but take it to your specialized
dealer whenever it is damaged, or contact our service hot line.
4. Only use films of the correct size (up to DIN A4 max.) and thickness (80 to 100 microns).
Films that are too thin cause a blockage of the film in the machine.
5. Do not touch the hot surface of the machine after it has started up.
6. The laminating machine is not allowed - for safety reasons - to be used by children,
unless they are supervised by an adult.
7. Never use the machine outdoor or near water.
8. Hot lamination: do not laminate in this mode any materials that are sensitive to heat
with this machine, like thermo-fax paper for example. These materials are only suitable
for cold lamination.
9. Do not pour or spill any liquid into the machine or onto it.
Laminator, A4
Manual
91610

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 91610 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ednet 91610

  • Page 1 Laminator, A4 Manual 91610 The laminator is only suitable for laminating documents. Any other use or modification shall be deemed to be improper and involves substantial risk of accidents. Important advice about safety 1. Read through these operating instructions carefully and completely before using the machine for the first time.
  • Page 2 10. Do not insert any metal objects into the machine. Please do not grasp inside the machine with your fingers. 11. The laminating machine is unsuitable for constant use commercially. It is recommended to switch “O” the machine for 30 minutes, after it has been operating for a period of approximately 30 minutes.
  • Page 3 Clearing a blockage of the film 1. This machine is equipped with a film blockage function in order to resolve any blockage of the film. Such function is featured by ABS button on BACK SIDE of the laminator. 2. Please switch off the machine immediately by setting the switch to “O” and pull out the plug from the mains socket outlet, let the machine to cool down briefly (for hot laminating) and push the ‘ABS’...
  • Page 4 Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the requirements of Directive 2014/30/EU (EMC), Directive 2014/35/EU (LVD) and the Directive 2011/65/EU for RoHS compliance. The complete declaration of conformity can be requested by post under the below mentioned manufacturer address.

Table of Contents