Summary of Contents for CCTV POE-SW1616
- Page 1 POE-SW1616 16 Port PoE Network Switch Quick Installation Guide & User Manual 16-port 10/100M Power over Ethernet Switch (AF Version 15.4W) Rev 1.01 01/20/2012...
-
Page 2: Table Of Contents
Table of Contents • Introduction ………………………………………………….. Page 2 • Power Over Ethernet (PoE) & Features ……..………….. Page 2 • Unpacking and Installation ……… .……………………….. Page 3 • System Requirement……. .……………………………….. Page 3 • Hardware Installation… …………. …………….……….….. Page 4 • Front /Rear Panel /LED….………………………………… Page 5 •... -
Page 3: Introduction
1. Introduction The POE-SW1616 16-port 10/100M Ethernet PoE switch a high efficiency 16-port 10/100Mbps Ethernet switch and a standard 802.3af 16-port Power over Ethernet (PoE) capability. The 16-port 10/100M Ethernet PoE switch incorporates an internal 48VDC power supply. Each of the PoE Ethernet ports can support 15.4W(AF) Watts of power as well as 10/100M data transmission over the Inter- connecting Ethernet interface such as Cat 5/ 5e /6 cables. -
Page 4: Unpacking And Installation
3. Unpacking and Installation Open the shipping cartons of the 16-port 10/100M Ethernet PoE Switch and carefully unpack its contents. The cartons should Included following items: One 16-port 10/100M Rack Mount Ethernet PoE switch One AC power cord ... -
Page 5: Hardware Installation
5. Hardware Installation A: Connect the AC Power Cord to the16-port 10/100M Ethernet PoE switch and then to a power outlet. AC power Outlet AC Power Cord B: Connect a CAT-5, CAT-5e or CAT-6 RJ-45 network cable from the computer to an available Ethernet port on the 16-port 10/100M Ethernet PoE switch. -
Page 6: Front /Rear Panel /Led
6. Front Panel/LED/PoE Network Front Panel Power LED PoE LED PoE Port Act/Link LED Power LED LED on: Power ON / LED off: Power off. LINK/ACT LED LED on: this port is Link and Active LED off: this port is not correct Link or inactive PoE (1 to 16) LED LED on: The PoE power device (PD) is connected and the port is supplying power successfully LED off: no PoE power device (PD) connected... -
Page 7: Connecting Ethernet Cable
6. Connecting Ethernet Cables PoE Ethernet Network Diagram PoE: Data + 48VDC Data workstation workstation INTERNET Broadband Router 16-Port 10/100 PoE Device Ethernet PoE Switch Touch Screen PoE Device PoE Device PoE Device PoE IP Camera PoE VoIP Phone Wireless Access Point Page: 2 of 2 16-port 10/100M Ethernet PoE switch... -
Page 8: Technical Specification
7. Technical Specifications Standard IEEE 802.3 10BASE-T Ethernet IEEE 802.3u 100BASE-TX Fast Ethernet IEEE 802.3x Full Duplex Flow Control IEEE 802.3af Power over Ethernet Protocol CSMA/CD Data Transfer Rate Ethernet: 10Mbps (half-duplex), 20Mbps (full-duplex) Fast Ethernet: 100Mbps (half-duplex), 200Mbps (full-duplex) Network Cables 10BASE-T: 2-pair UTP Cat 3, 4, 5 up to 100 meters. -
Page 9: Troubleshooting
8. Troubleshooting 1> After connecting the Switch to a power outlet, the LEDs do not turn on. Check the connection of the power cord to the 16-port 10/100M Ethernet PoE switch and the power outlet check that the power outlet is receiving power. 2>...