Summary of Contents for LinkSprite DMX512
-
Page 1: User Manual
WiFi DMX512 Adapter User Manual May 2011 LinkSprite Technologies, Inc sales@linksprite.com 1 / 8... - Page 2 LinkSprite WiFi DMX512 adapter can bridge DMX512 signal from DMX512 controllers to WiFi signal, and achieve the target of replacing DMX cables by WiFi network. The adapter has both physical and logic addresses. In a network setup, both physical and logic addresses can be used to address different nodes in the WiFi network.
- Page 3 Specification: Model LS-WIFI-DMX512 Interface DMX512/RS485 Power Supply 7V-40V DC Antenna External Antenna LED Indicator One shared power status LED 3 / 8...
- Page 4 After power on, WiFi DMX512 adapter will search for network, and search for other peer WiFi DMX512 devices to connect. In the search process, WiFi DMX512 adapter will enter into AT mode, and will stay in AT mode until other peer devices are found.
- Page 5 Addressing 1. The ATHA command can be used to check the MAC address of device itself. When argument is used, it is used to set the destination MAC address. (FF-FF-FF-FF-FF-FF means broadcasting). The total length if 17 includes the delimiter’-‘. 2.
- Page 6 Examples Point to point mode: To put two devices work in point to point mode, we need to set the destination MAC of the pair to be the MAC of the other device (use ATHA command). DN of the two devices can be set to 0xFFFFFFFFFFFF, or the domain part of DN of source be same as the domain part of destination Broadcast mode: To put the device into broadcast mode, MAC addresses of all the devices...
- Page 7 Application Illustration 7 / 8...
- Page 8 LinkSprite Technologies, Inc. 1 067 S Hover St, Unit E-186,Longmont, CO 80501 ： 720-204-8599 ： Email s ales@linksprite.com ： Technical questions: forum.linksprite.com w ww.linksprite.com, ： 8 / 8...
Need help?
Do you have a question about the DMX512 and is the answer not in the manual?
Questions and answers