Summary of Contents for GSE AIR’SYSTEM
- Page 1 AEROVOLTAICS AIR’SYSTEM ™ V3.0 USER MANUAL - GSE AIR’SYSTEM THERMOSTAT Hot air recovery and redistribution system for home heating GSE INTEGRATION V 3.0 SMABTP CERTIFIED...
- Page 2 AIR’SYSTEM ™ When energy savings meet optimal thermal comfort...
- Page 3 Your new photovoltaic panel heat recovery system has just been installed. The heat generated by your solar panels is now ready to work for you. To grasp how your GSE AIR’SYSTEM works, please read this manual. It also contains very easy instructions for using the thermostat.
- Page 4 19°C 19°C In this case, there is more than enough heat under the panels to warm your home, so your GSE AIR’SYSTEM does not need to trigger the SPEED HEATING unit. It simply adjusts the ventilation speed so your home is warmed to the desired temperature without any “hairdryer effect”.
- Page 5 23°C At night, the temperature under the panels is usually 3° or 4°C lower than the temperature in your home. Your GSE AIR’SYSTEM collects this cooler air and routes it to the air vents(*). The system automatically switches into this mode after 3 consecutive nights without a heating request (i.e.
- Page 6 Your technician will install the thermostat in the room of your ➤ Ambient choice. It is this device which will tell to GSE AIR’SYSTEM Température ➤ whether to send hot air into your house or not. To adjust it, nothing’s easier: just press the buttons (+) and (-) to set the...
- Page 7 Thermostat user manual AIR’SYSTEM ™...
- Page 8 Notice du thermostat...
- Page 9 Notice du thermostat AIR’SYSTEM ™...
- Page 10 WebServer user manual QUICK ACCESS TO GSE AIR’SYSTEM WEBSERVER : Your technician has created you an online tracking page of your GSE Air’System’s performances. To access it, go to the website https://cloudigo.regin.se/login provided your access codes available from your installer.
- Page 11 • STOP : This state means that under panels sensor doesn’t measure a sufficient temperature to start GSE AIR’SYSTEM. The minimum available temperature under modules required to exit of this state is 17°C. Even if the thermostat state is ON.
- Page 12 WebServer user manual • ExHAUST : this state is automatically launched when under panels temperature exceeds 25°C AND the thermostat state is OFF. • ROTATION : this state means that GSE AIR’SYSTEM is changing of operating state.
- Page 13 WebServer user manual • FREECOOLING : this state is automatically launched on summer nights, when under panels temperature is at least in under 2°C from inside measured temperature (only after 3 days in a row without thermostat state is ON. •...
- Page 14 WebServer user manual • STOP MODE : allows to totally stop GSE AIR’SYSTEM. It is advised to not use this mode, otherwise you could not benefit of expected energy savings. • FREECOOLING MODE : this mode allows you to force free cooling even if all necessary...
- Page 15 Answer: It’s used to boost the temperature of the air drawn from under the panels when it’s not warm enough. For instance, if you’ve set the thermostat to 21° and the air under the panels is at 20°, the GSE AIR’SYSTEM heats this air to the desired temperature.
- Page 16 155-159 rue du Dr Bauer - 93400 SAINT-OUEN Tél.: +33 1 70 32 08 00 Email : contact@gseintegration.com www.gseintegration.com...