Advertisement
BLACK BOX
6. How to Install
1) Install the Urive single HD SD card to the main device.
2) Select a location for attaching the main device.
3) Clean the area on the windshield where the product is to be installed.
4) Remove the cover sheet from the adhesive tape on the holder.
5) Affix the Urive single HD at the desired position.
6) Connect the main power cable(cigar cable) to the DC port.
7) Connect the cigar cable to the car cigar socket.
8) The LED will be turned on after the power switch is "ON" and then the device is started
with buzzer sound.(Before finishing, please check the front/rear views are normally
recorded and stored)
9) After booting, the RED LED will be turned on and start a video recording.
10) The camera's shooting angle can be adjusted on the screen when the Video cable is
connected to navigation AV-IN or CAM terminal.
11) After adjusting the camera's shooting angle, please fastened the device on the holder.
12) If users install the GPS, please make sure the power off before installing.
※ Caution
- Before placing the cables in the groove, please check the video images are normally stored
in the memory card.
- After installing the camera, remove the protective plastic film from the camera lens.
- In case of No. 8~ 9), they are relevant in driving mode.
URIVE SINGLE PLUS
Advertisement
