Table of Contents
Advertisement
E. REMOVING DOOR (Figure 14)
(1) Remove the vent grille by removing two screws
securing it to the Outer Case loosening.
(2) Lift up and draw the door.
NOTES:
• After replacing the door, be sure to check that the
primary interlock switch, the secondary interlock
switch and the interlock monitor switch is in good
operating normally.
• After replacing the door, check for microwave energy
leakage with a survey meter. Microwave energy
leakage must be below the limit of 5mW/cm
275 ml water load)
F. DISASSEMBLING DOOR (Figure 15)
(1) Remove the dielectric choke by using knife blade
or small screw driver, etc.
(2) Remove two screws securing it to the door handle.
CAUTION: Be careful not to damage door seal
plate with the screwdriver.
Figure 15
Figure 14
Door Screen
2
. (With a
7-9
Hide quick links:
Advertisement
Table of Contents
