Brisa BW3501 Owner's Manual

O ' G
WNER S UIDE
U C M
SE AND ARE ANUAL
WINDOW COOLER MODELS

For Customer Assistance

CALL 1-800-325-6952
DO NOT RETURN TO PLACE OF PURCHASE!

Safety

Operation
Installation
Maintenance
Start-up Troubleshooting
Read all instructions carefully before installation.
This cooler must be connected to 120 Volt AC, 60 Hz (cycle)
power only. NOTE: Improper voltage will void the pump and/or
motor warranties and may cause serious personal injury or
property damage.
This cooler must be plugged into a GFCI protected receptacle,
which has been properly installed in accordance with all local
and national codes. If you are not sure that the receptacle is
GFCI protected, consult with a qualified electrician.
This cooler is equipped with a power cord having an equipment
grounding conductor and grounding plug. Do not attempt to
defeat this safety device by removing the grounding pin.
Use of an extension cord is not recommended.
Do not operate if plug or cord is damaged in any way. If the unit
is damaged or malfunctions, do not continue to operate it.
Always disconnect electrical power to unit before attempting to
work on or service your cooler.
Some models may have a restricting orifice in the pump water
tube to assure proper water flow rate to the pad. Do not remove
this restrictor!
P M
HOENIX ANUFACTURING,
BW3501 / BW3501MX
BW4002 / BW4002MX
BW4502 / BW4502MX
BW5002 / BW5002MX
Congratulations: You have purchased a product of superior performance and design,
which will give the best service when properly installed, operated and maintained.
This guide will provide you with information needed to mount, operate, inspect, maintain,
and troubleshoot your Brisa window evaporative air cooler.
The first section, Installation and Start-Up, gives details for installation. The second
section, Maintenance, contains operational and maintenance instructions, while
Troubleshooting includes information on commonly encountered problems.
INSTALLER: Please deliver this guide to owner.
WARNING -
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING.
Remove the plug from the electrical receptacle by pulling on
the plug and not the cord.
Do not operate this blower (fan) motor with any solid-state
speed control device.
Do not operate this unit with pad frame(s) and/or air outlet grille
removed, this may cause the fan motor to overload and
damage the motor.
NOTE:
Do not locate unit near exhaust or vent pipes as odors or fumes
may be drawn into cooler.
Use of anode devices, chemical additives or treatments in this
cooler will void the warranty.
Your warranty does not cover shipping damage. Report all
shipping damage at once to dealer or carrier making the delivery.
For future reference, record the model and serial numbers, date
and place of purchase of your evaporative cooler here:
Model #
Serial #
Date of Purchase:
Place of Purchase:
1-999-2431
I
NC.
Date: 01/13