Installation; Transportation Instructions; Installation Instructions - Beko LRP 1685 X User Manual

3

Installation

Transportation
Instructions
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of
transport the appliance has to be
transported horizontally, the product
must only be laid on its right hand
side (when facing the door front) and
it must not be operated for at least
4 hours to allow the system to settle
after the appliance is brought back to
upright position.
3. Failure to comply with the
instructions could result in damage
occurring to the appliance. The
manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be
protected against rain, moisture and
other atmospheric influences.
5. When positioning your
appliance take care not to damage
your flooring, pipes, wall coverings
etc. Do not move the appliance by
pulling by the door or handle.
6. Empty any water in the drain
tray and Water Dispenser tank before
moving. See section 'Defrosting'
and 'Care & cleaning' for further
information.
7. Make sure that the defrost
water pipe at the back of the product
is fixed to the plastic evaporating pan
on the top of the compressor, to avoid
defrost water spillage on the floor.
Important
Care must be taken when carrying
the appliance to avoid touching
the bottom of the condenser metal
support/pipework at the back of the
appliance as you might injure your
fingers and hands or damage your
product.
Important
Make sure that mains cable is not
caught under the appliance during and
after carrying/moving the appliance,
to avoid the mains cable becoming cut
or damaged.
Do not attempt to sit or stand on top
of your appliance. You could injure
yourself and damage the appliance.
Beko declines to accept any liability
should the
followed.
Installation
Instructions
1. Fit the two plastic wall spacers
supplied with the appliance onto
the condenser at the back of the
appliance by rotating 1/4 turn.
Locate the appliance on a
2.
smooth surface.
11
EN
instructions not be