SAFETY PRECAUTIONS This device is to be serviced only by properly qualified service personnel. Consult the service manual for proper service procedures to assure continued safety operation and for precautions to be taken to avoid possible exposure to excessive microwave energy. PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE...
SPECIFICATION ITEM DESCRIPTIONS MODEL MA-972M, MA-972MW Power Requirement 120 V AC, 60Hz 1,500 W (13.5A) Single phase, 3 wire grounded Power Output 1000 Watts full microwave power (IEC705) Microwave Frequency 2,450MHz Magnetron 2M246 Timer 0 - 99min. 99sec. Outside Dimensions 20"(W) x 11...
CAUTIONS Unlike other appliances, the microwave oven is MICROWAVE RADIATION high-voltage and high-current equipment. Personnel should not be exposed to the Though it is free from danger in ordinary use, microwave energy which may radiate from the extreme care should be taken during repair. magnetron or other microwave generating device if it is improperly used or connection.
INSTALLATIONS BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY. Installing microwave oven Grounding Instructions 1. Empty the microwave oven and clean inside it with For personal safety, this appliance must be fully a soft, damp cloth. Check for damage such as grounded at all times.
OPERATING INSTRUCTIONS Features Oven Front Plate Window Door Screen Door Seal Display Window Control Panel Door Open Button Safety Door Lock System Turntable Rotating Ring Control Panel ONE TOUCH PLATE OF POPCORN POTATO FOOD ENTREES DINNERS INTERNATIONAL FOODS ITALIAN SPANISH ORIENTAL MEAT AUTO WEIGHT...
Operating Sequence The followings are description of component functions 5. Multi Stage Cooking during oven operation. 1st stage 1. Setting the clock STOP/CLEAR TIME POWER NUMBER CLOCK NUMBER CLOCK STOP/CLEAR NUMBER ex) To set 4:30, touch number key [4],[3], and [0]. 2nd stage NOTE: 1) This is a 12 hour clock.
Circuit Description • The low voltage transformer supplies the necessary A high voltage of approximately 2100 volts AC is voltage to the micom controller when power cord is generated in the secondary of the high voltage transformer which is increased by the action of the high plugged in.
Need help?
Do you have a question about the MA-972M and is the answer not in the manual?
Questions and answers