MATSONIC ra3800 Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Matson Jump Starter

Operator's Manual

RA3800

SAVE THESE INSTRUCTIONS:

This manual contains

important safety and operating instructions for the RA3800

Jumpstart. Read through this owner's manual carefully before

using. Please read all safety, warning and caution instructions

carefully.

Table of Contents

Need help?

Do you have a question about the ra3800 and is the answer not in the manual?

Questions and answers

Summary of Contents for MATSONIC ra3800

Page 1 Matson Jump Starter Operator’s Manual RA3800 SAVE THESE INSTRUCTIONS: This manual contains important safety and operating instructions for the RA3800 Jumpstart. Read through this owner’s manual carefully before using. Please read all safety, warning and caution instructions carefully.
Page 3 The jump starter described in this manual is suitable for portable power and emergency power applications. Ratings are described as below. RA3800: 12/24V 2x20AH AGM battery, 1000/500 CCA, 50mm2 boost cable with copper jaws. CAUTION: Contains sealed, non-spillable lead acid battery. Must be disposed of properly.
Page 4 and personal metal items when working with a lead-acid battery. Do not use the portable power source to charge dry-cell batteries. These batteries may burst and cause injury and damage to persons or property. Do not attempt to charge or boost a frozen lead-acid battery.
Page 5 The power source can only be charged at 12V. Turn switch to 12V System and Recharge then recharge power source. Figure 1. Test button, Charging and Charge Volt Meter Model: RA3800 Important! Charge Jump Start for a minimum of 24 hours prior to initial use.
Page 6 Once the charged light comes on, device can be disconnected from the Switching Power Charger. Note: You can press the TEST button to check power level. OPERATING INSTRUCTIONS USE AS A BATTERY CHARGER The portable power source can be used to restore a limited charge to the vehicle battery.
Page 7 (positive +) from the battery terminal. The yellow Charging light will remain lit until the red (positive +) cable is disconnected from the battery. After use, store the clamps in the compartments. USE AN AS ALTERNATIVE POWER SUPPLY Since most vehicles have electronic components (alarm systems, radios, etc) whose memory can be lost when the battery is disconnected, the portable power source is a useful tool when replacing a battery.
Page 8 TROUBLESHOOTING Charger works well but there a) Possible defective battery is no volt charge on the volt or faulty breaker. Try using meter when the Switching a device (light, TV, etc) Power Charger is connected to with a DC plug on it to see the Portable Power Source.
Page 9 Q: What is the ideal storage temperature of the portable power source? A: The portable power source will operate most effectively when stored at room temperature. The unit will also operate under below zero degree conditions, but with less cranking power.
Page 10 1. Lay the portable power source front side down. On the back of the unit, locate the screws that hold the portable power source enclosure together. 2. Remove the screws, then lift off the back lid of the portable power source enclosure. 3.
Page 12 THE COMPANY DOES NOT AND SHALL NOT BE LIABLE FOR ANY LOSS, CLAIM, INJURY OR DAMAGE, TO ANY PERSON OR PROPERTY, OR LOST PROFITS OR OTHER SIMILAR LOSS OR DAMAGE, WHICH MAY ARISE, DIRECTLY OR INDIRECTLY, RESULT OR BE CLAIMED TO HAVE RESULTED FROM A DEFECT IN MATERIALS OR WORKMANSHIP OF THE PRODUCT THE COMPANY’S LIABILITY, IF ANY, SHALL NEVER EXCEED THE PURCHASE PRICE OF THIS PRODUCT REGARDLESS OF...