Connections / Initial Setup (Ready To Play) - Panasonic PV C2062 Operating Instructions Manual

Connections/ Initial Setup
Please make all cable or antenna connections before powering on.
How to Connect
Connecting
For ANT./Cable
Connect the cable from
Antenna/Cable to the VHF/UHF
terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on your
cable box to the VHF/UHF
terminal on the unit with a RF
cable.
WARNING:
Overtightening "Nut type" RF coaxial cables
may damage jacks. Finger tighten only.
Initial Setup (Ready to Play)
Press Combo on the remote for Combo
mode.
1
Plug the unit power cord into an
AC wall outlet.
Press Power* on the remote or
2
unit. The unit comes on and auto
channel and clock set starts.
CH AUTO SET PROCEEDING
• If you use a cable box, turn it on and set it to the
Public Broadcasting Service (PBS) channel in
your time zone. If you use a DSS reciever, it
must be turned off.
AUTO CLOCK SET
CANCEL : PRESS STOP KEY
8
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
PROCEEDING
(Ready to Play)
VHF/UHF
VHF/UHF
UNIT
VHF/UHF
3
Settings are made
automatically. When setup is
done, this screen appears.
2 / 6 / 2002 WED 12 : 00PM
SETT I NG : CH 1 0
AUTO CLOCK SET
COMPLETED
If AUTO CLOCK SET IS
INCOMPLETE screen
appears, set the clock using
MANUAL CLOCK SET
procedure as below.
SET CLOCK
2 / 6/ 2 / 6/ 2002 2002 WED
SET COMPLETED SE COMPLETED
SET :
START
IN from
ANT./CABLE
Cable TV
Converter Box
IN from
ANT./CABLE
DST : ON
:
WED 12 12 00 00PM PM
DST : ON
: ACT I ON