Advertisement
Available languages
Available languages
INSTALLATION
Flush Installation
To ensure a proper installation, a template for the countertop
cut-out should be created using the cooktop glass.
ROUTING OPTION
For this installation, a recessed area surrounding the coun-
tertop cut-out is required. Fabrication of the recessed area
must take place before the countertop is installed.
This option is not recommended for countertops with a
molded backsplash.
CLEAT OPTION
For this installation, the countertop cut-out will be the same
size as the outer edge of the cooktop glass.
Attach L-shaped cleats to the perimeter of the countertop
cut-out. The top edge of the cleat can not be wider than
22 mm and will be attached 8 mm below the surface of the
countertop. Refer to the illustration below. Attach the cleats
to the countertop. Consult a countertop supplier for proper
methods of attachment.
8 mm
L-SHAPED
CLEATS
22 mm
Support cleats.
Cooktop Installation
Remove the cooktop and components from the shipping
package and recycle packing materials.
Lower the cooktop into the countertop cut-out. Center the
cooktop in the opening with the front edge aligned parallel
to the front edge of the countertop. Using a pencil, outline
the rear edge of the cooktop on the countertop. Remove the
cooktop.
Apply the foam strip provided, to the perimeter of the coun-
tertop opening. Refer to the illustration below. Do not seal
the cooktop to the countertop.
Insert the cooktop into the opening. Verify the cooktop is
aligned with the front edge of the countertop.
Attach the brackets provided, to the bottom of the unit.
Insert the 89 mm clamping screws into the brackets. Use
a screwdriver to tighten the clamping screws against the
bottom of the countertop. Do not overtighten screws. Refer
to the illustration below.
FOAM STRIP
COUNTERTOP
BRACKET
CLAMPING
SCREW
Cooktop installation.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero, Sub-Zero
& Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks of
Sub-Zero, Inc. (collectively, the "Company Marks.") All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
Troubleshooting
IMPORTANT NOTE:
If the cooktop does not operate prop-
erly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the cooktop.
•
If the cooktop does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
cooktop. Wolf is not responsible for service required to
correct a faulty installation.
wolfappliance.com
|
5
Advertisement
