Appendix B - Clear Connect Frequency Changing For Systems With Multiple Rf Links - Lutron Electronics launchport am.2 Manual

Appendix B – Clear Connect Frequency Changing for Systems with
Multiple RF Links
In RadioRA 2 systems with two Main Repeaters or in HomeWorks QS systems with multiple RF
Links, there may be a need to change the frequency (RF channel) of the product so that it can
communicate to the system. This is because every RF link communicates at a different
frequency and because the LaunchPort Sleeve Buttons are acting as a transmitter only. Unlike
unassigned Lutron RF dimmers or keypads which can channel scan and identify an RF Link in
Activation mode, in any of the 15 available channels, the LaunchPort Sleeve Buttons cannot
receive or listen to these commands and must be forced to a different frequency.
For more information on these processes in a HomeWorks QS system, refer to the "One-Way
Transmitter Frequency Change Procedures" application note on the Resource Site:
http://resi.lutron.com/Portals/3/Support/App%20Notes%20-
%20FAQs/HWQS/HWQS%20OWT%20Device%20Freq%20Change%20Procedure%20Rev%2
0A.pdf
For more information on these processes in a RadioRA 2 system, refer to the "RadioRA 2 One-
Way Transmitter Frequency Change Procedures" application note on myLutron:
http://www.lutron.com/PasswordProtectedDocumentLibrary/OWT%20Device%20Freq%20Chan
ge%20Procedure%20for%20Multi-Channel%20Systems%20revision%20E.pdf
22 | P a g e