Cassette Tapes - Panasonic SC-PM19 Operating Instructions Manual

4
4
/REW/ ,
¢
3
/FF/
7
STOP ,
–DEMO
OPEN 0
1
2
3
TAPE
3
VOLUME
DOWN
20
RQT7369
Top of the unit
OPEN
1
3
2
Insert inside the
guides
Forward side
UP

Cassette tapes

1
Press [OPEN 0] to insert a cassette.
Close the lid by hand.
2
Press [TAPE 3] to start playback.
Repeat step 1 and 2 to play the other side of the tape.
3
Adjust the volume.
To Action
Press [STOP 7, – DEMO].
stop tape playback
Press [TAPE 3] when the system is
start one touch play
OFF with the cassette loaded.
fast-forward and Press [4 4 4 4 4 /REW/4] or [3 3 3 3 3 /FF/¢] in
rewind the stop mode.
Cassette tape selection and care
Types of cassettes which can be played correctly
Use normal position tapes.
High position and metal position tapes can be played, but the
unit will not be able to do full justice to the characteristics of
these cassettes.
• Tapes exceeding 100 minutes are thin and can break or get
caught in the mechanism.
• Tape slack can get caught up in the mechanism and should
be wound up before the tape is played.
• Endless tapes can get caught up in the deck's moving parts
if used incorrectly.
To find the beginning of a program
(TPS: Tape Program Sensor)
TPS finds the beginning of a track and resumes play from there.
Each press increases the number of tracks skipped, up to a
maximum of 9.
Press [4 4 4 4 4 /REW/4] or [3 3 3 3 3 /FF/¢] during play.
Note
The TPS function searches for silent parts of about 4 seconds
in length which are normally found between tunes. As a result,
it may not function properly in the following cases:
• With short silent parts
• When noise occurs between tunes
• With silent parts found within tunes