Table of Contents
Advertisement
Quick Links
INSTALLATION, OPERATING, AND
SERVICE INSTRUCTIONS
HEAT-FLO HOT WATER STORAGE/ BOOSTER TANKS
MODELS 30-ST, 40-ST, 40L-ST, 60-ST, 60L-ST
For service or repairs to the water heater, call your heating contractor. Your water heater has been manufactured
to provide years of service. In order to insure proper service, the following information is provided to assist
in enabling the installation, operation, and maintenance of this water heater. For your comfort, safety, and
convenience, we recommend that this water heater be installed and serviced by a plumbing professional. When
the installation is completed, keep this manual with the water heater. Information and specifications outlined
in this manual in effect at the time of printing of this manual. Heat-Flo reserves the right to discontinue, change
specifications, or change system design at any time without notice.
80-ST, 115-ST, 80-ST-C, 115-ST-C
Heat-Flo, Inc.
15 Megan Ct., P.O. Box 612 Uxbridge, MA 01569 USA
Conforms to UL STD 174 and NSF/ANSI 372
Certified to CAN/CSA STD C22.2 No. 110-94
Bulletin I0-ST-010115
Advertisement
Table of Contents
Related Manuals for Heat-Flo 115-ST-C
Summary of Contents for Heat-Flo 115-ST-C
- Page 1 Information and specifications outlined in this manual in effect at the time of printing of this manual. Heat-Flo reserves the right to discontinue, change specifications, or change system design at any time without notice.
-
Page 2: Safety Information
Safety I nformation The f ollowing t erms a nd s ymbols a re u sed t o b ring a ttention t o t he p resence o f various ... - Page 3 IMPORTANT I NFORMATION – R EAD C AREFULLY NOTE: The equipment shall be installed in accordance with those installation regulations required in the area where the installation is to be made. These regulations shall be carefully followed in all cases. Authorities having ...
- Page 4 IMPORTANT S AFETY I NSTRUCTIONS READ A LL I NSTRUCTIONS B EFORE U SING T HIS W ATER H EATER. WARNING – W hen u sing e lectrical a ppliances, s afety p recautions s hould b e t aken t o r educe t he risks ...
- Page 5 Hot Water Storage/ Booster Tanks Figure 1 Fully insulated stainless steel tanks, including L4080B aquastat. Brass drain and T&P valves are factory installed. Fully insulated stainless steel tanks, including L4080B aquastat. Brass drain and T&P valves are factory installed. Dip tubes in tank located to circulate water through the heat source and return to the tank.
-
Page 6: Pre-Installation Considerations
Pre-‐installation C onsiderations Inspect s hipment c arefully f or s igns o f d amage. A ll e quipment i s c arefully i nspected a nd p acked. Heat-‐Flo’s ... - Page 7 ADDITIONAL R ECOMMENDED C OMPONENTS 1. Shut-‐Off Valves: Allows the isolation of the water heater from the boiler system during s ervice. 2.
- Page 8 2. Position t he w ater h eater i n i ts f inal l ocation 3. Connect t he c old w ater s upply p iping. •...
-
Page 9: Operation
5. Fill t he w ater h eater. • Open all faucets to allow air to purge from the tank and piping. Remove screens on faucets. ... -
Page 10: Water Temperature Adjustment
WATER T EMPERATURE A DJUSTMENT It i s r ecommended t hat t he t hermostat b e s et f or t he l owest p ossible t emperature t hat s atisfies your ... - Page 11 It is the responsibility of the installing contractor to see that all controls are correctly installed a nd a re o perating p roperly w hen t he i nstallation i s c omplete. DO ...
- Page 12 ABOVE A LL, D O N OT P LUG T HE T EMPERATURE A ND P RESSURE R ELIEF V ALVE. T HIS I S N OT A SOLUTION ...
-
Page 13: Replacement Parts List
Replacement P arts L ist Heat-‐Flo, I nc. | H ot W ater S torage/ B ooster T anks Page | 1 1 ... - Page 14 Heat-‐Flo, I nc . LIMITED W ARRANTY FOR H OT W ATER S TORAGE T ANKS These H eat-‐Flo, I nc. w arranties p rotect y our i ndirect-‐fired w ater h eater. T hese w arranties a re a pplicable t o t he o riginal p urchasers o nly. WARRANTY ...
-
Page 15: Owner's Responsibilities
The obligations under this warranty apply only to domestic hot water tank installations where the warranty registration card has been completed by the owner of the site of the original installation and received by Heat-Flo in accordance with the terms and conditions herein set out and Heat-Flo has been notified of the alleged defect or deficiency within forty eight (48) hours from the occurrence or discovery of the alleged defect or deficiency. - Page 16 Providing Solutions through Superior Design. Heat-Flo, Inc. 15 Megan Ct., P.O. Box 612, Uxbridge MA, 01569, USA Phone: (508) 278-2400 | Fax: (508) 278-2466 | e-mail: sales@heat-flo.com www.heat-flo.com...
Need help?
Do you have a question about the 115-ST-C and is the answer not in the manual?
Questions and answers