Advertisement
Quick Links
Download this manual
See also:
User Manual
This Quick Start Guide covers the steps required for physical installation of an ADC In-Building
Wireless Repeater, and the initial power up instructions of the repeater. For additional information
and advanced installation instructions, refer to the ADC In-Building Wireless Repeater User Manual
(catalog number ADCP-75-237). A copy of the manual is on the enclosed CD.
Repeater must be configured before it is functional. See repeater User Manual (catalog number
ADCP-75-237) for configuration instructions.
1
INSTALLER OR CUSTOMER SUPPLIED ITEMS
Hardware to secure wall mount bracket to wall.
◗
Dedicated AC power source for each unit.
◗
Coax cable and donor antenna with mount.
◗
Coax cable and service antenna with mount.
◗
Appropriate tools (hand and power) to mount repeater and antenna.
◗
Computer to load the GUI software and configure the repeater.
◗
KIT CONTENTS SUPPLIED BY ADC
USB (A to A) cable
◗
Power supply
◗
Power cable
◗
Repeater mounting bracket
◗
Repeater
◗
CD with documentation and GUI software
◗
2
CHOOSE SUITABLE REPEATER AND ANTENNA LOCATIONS
The best repeater location is a place as close as possible to the donor antenna. Maximum
◗
coax cable length is based on link budget.
Choose a repeater location that is central to your users preferably in an equipment closet or
◗
other out of the way location.
Choose a repeater location within 8 to 10 feet (2.5 to 3 meters) of an AC outlet.
◗
Service and donor antennas should be located at different heights to avoid interference.
◗
9/2007
ADCP-75-239
1416981 Rev B
ADC In-Building
Wireless Repeater
Quick Start Guide
© 2007, ADC Telecommunications, Inc.
Advertisement
Related Manuals for ADC ADCP-75-237
Summary of Contents for ADC ADCP-75-237
- Page 1 Wireless Repeater Quick Start Guide This Quick Start Guide covers the steps required for physical installation of an ADC In-Building Wireless Repeater, and the initial power up instructions of the repeater. For additional information and advanced installation instructions, refer to the ADC In-Building Wireless Repeater User Manual (catalog number ADCP-75-237).
- Page 2 C H K S L E P O W REPEATER MOUNTING 22108-A SCREWS MOUNTING (4 PLACES) BRACKET Figure 1. Repeater Installation Slide the repeater with bracket into slot in the mounting bracket. ◗ Page 2 © 2007, ADC Telecommunications, Inc.
-
Page 3: Connect The Cables
◗ service), one power connector, and one USB port. Connect cables at the locations shown in Figure 2 DONOR ANTENNA CONNECTOR POWER SOCKET LOCATION SERVICE ANTENNA CONNECTOR PORT LOCATION Figure 2. Connect Cables Page 3 © 2007, ADC Telecommunications, Inc. -
Page 4: Install Software
When message “Successful installation completed” appears, click “OK” button. The window will automatically close. You do not need to re-start the computer to begin using the program. For additional installation information refer to the User Manual (ADCP-75-237). Page 4 © 2007, ADC Telecommunications, Inc. - Page 5 “It's not available” on the screen and requests that you select another port. You are now ready to configure the repeater to your system requirements. Refer to repeater User Manual (catalog number ADCP-75-237) for band selection, RF parameters, and alarm functionality. Page 5...
-
Page 6: Customer Information And Assistance
Contents herein are current as of the date of publication. ADC reserves the right to change the contents without prior notice. In no event shall ADC be liable for any damages resulting from loss of data, loss of use, or loss of profits and ADC further disclaims any and all liability for indirect, incidental, special, consequential or other similar damages.