Maintenance & Lubrication Charts; General; Maintenance Charts - Jacobsen GA 24 Technical Manual

9.1 9 MAINTENANCE & LUBRICATION CHARTS

GENERAL ________________________________________________________________

!
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the ground,
engage parking brake, stop engine and remove key
from ignition switch to prevent injuries.
1. Always clean the grease fitting before and after
lubricating.
9.2

MAINTENANCE CHARTS ___________________________________________________

Air Filter
Cam Case Oil
Engine Oil
Grease Fittings
Hydraulic Hoses and Tubes
Hydraulic Oil
Muffler and Exhaust
Tires
Front Wheel Bearings
A - Add or Adjust
* Replace oil after initial 5 hours of operation.
** Or every two years whichever comes first.
*** Inspect visible hoses and tubes for leaks or oil marks.
MAINTENANCE & LUBRICATION CHARTS
Recommended Service and Lubrication Intervals
Every Every Every
8-10 25 100
Hours Hours Hours
I C R
I-R* R
L
I***
I-A
I
I-A
C - Clean I - Inspect
2. Lubricate with grease that meets or exceeds NLGI
Grade 2 LB specifications. Apply grease with a
manual grease gun and fill slowly until grease begins
to seep out. Do not use compressed air guns.
3. For smooth operation of all levers, pivot points and
other friction points that are not shown on the
lubrication chart apply several drops of SAE 30 oil
every 40 hours or as required.
4. Apply #30 oil or penetrating chain lubricant daily.
5. Grease aerator crankshaft (3) and connecting rod
fittings (6) daily.
Every Every Every
250 400 500
Hours Hours Hours
C
I
R**
I
L- Lubricate R - Replace
- Manual grease gun with NLGI Grade 2 (Service Class
I
LB).
- Engine Oil - See Section 7.3.
II
III - Hydraulic Oil - See Section 7.7.
IV - SAE 30 Weight Oil.
Every Yearly See
1000 Section
Hours
R 7.4
7.3
7.6
7.7
7.8
7.9
L
AR - As Required
9
Lubricant
Type
IV
II
I
III
25