Summary of Contents for Goodyear GY-DI-10500-1
- Page 1 GY-DI-10500-1 500W IMPACT DRILL Website: www.gy-me.com Tollfree: 800 GOODYR(466397)
- Page 2 1. Chuck 2. Drill/hammer drill selector switch 3. Left/right switch 4. Speed control switch 5. On/off switch 6. Locking button...
- Page 3 CONTENT GENERAL POWER TOOL SAFETY WARNINGS................ p.02 SAFETY WARNINGS FOR IMPACT DRILL................p.04 TECHNCAL SPECIFICATI ON............... p.05 OPERATION....................p.05 MAINTENANCE ..................... p.06 GENERAL POWER TOOL SAFETY WARNINGS WARNING! – To reduce the risk of injury, user must read instruction manual. Warning Wear ear protection Wear eye protection...
- Page 4 GENERAL POWER TOOL SAFETY WARNINGS 2) Electrical safety a) Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. b) Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and refrigerators.
- Page 5 GENERAL POWER TOOL SAFETY WARNINGS e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
- Page 6 TECHNCAL SPECIFICATION Voltage supply 230V Frequency 50 Hz Rated Power 500W No-load speed 0-3000min-1 Chuck Capacity 10mm Maximum drilling diameter Concrete 10mm Steel 10mm Wood 20mm Sound pressure level 84dB(A) K=3 dB(A) Sound power level 95dB(A) K=3 dB(A) Vibration level: ah, ID=8.55m/s2 K=1.5 m/s2 ah, D=3.02m/s2...
- Page 7 OPERATION INSTALL/REMOVE A DRILL BIT 1) Open the chuck by turning the chuck counterclockwise. 2) Insert the bit shaft into the chuck. 3) Insert the chuck key into each hole in the side of the chuck and turn clockwise until tight. 4) To remove the drill bit, insert the chuck key into each hole in the side of the chuck and turn counter clockwise until loose.
- Page 9 CONTENT GENERAL POWER TOOL SAFETY WARNINGS................ p.02 SAFETY WARNINGS FOR IMPACT DRILL................p.04 TECHNCAL SPECIFICATI ON............... p.05 OPERATION....................p.05 MAINTENANCE ..................... p.06...
- Page 12 Goodyear (and winged foot design) and Blimp are trademarks of The Goodyear Tire & Rubber Com ny used under license by Focus Industries O/B Fortune Technology, Hong Kong. Copyright 2016 The Goodyear Tire & Rubber C mpany.
- Page 15 Attach Orginal Box and Receipt...
- Page 16 Focus Industries O/B Fortune Technology 2016...
Need help?
Do you have a question about the GY-DI-10500-1 and is the answer not in the manual?
Questions and answers