Advertisement
3) Insert one microphone into each of the shockmounts and use the Blumlein coupler to hold them together. Rotate one 45-degrees to the right
of center and the other 45-degrees to left of center.
4) Now, attach the array to your mic stand, using the 5/8-27 female to 3/8-16 (EU) stand adaptor. If needed, use the Posi-Lok adjustable angle
adaptor to allow adjusting the angle of the entire array.
5) Finally, insert the cables into the microphones and tie them securely to the fixture, allowing a slack-loop to complete the isolation from me-
chanical noise coming up the mic stand.
ribbonmics & preamps
www.ribbonmics.com | tel: +1-626-798-9128 | fax: +1-626-798-2378
since 1964
6
Advertisement
