Xircom REX6000 Quick Start Manual page 13

Resetting REX
On rare occasions, you may experience a system failure. REX's screen
may "freeze" and the touch screen and buttons will not operate properly.
If this happens, you will need to reset REX. When you reset the unit, all
your data will be kept intact except for anything you did not save before
the freeze.
To reset REX:
1. Unbend a paper clip and insert its end into the small hole on the back
of the unit. The hole is located near the edge opposite the battery
compartments. The Touch Screen Calibration screen displays.
Touch the center of the on-screen target. We suggest using the
stylus rather than your finger, for greater accuracy.
2. The target will move to a different location. Touch its center again.
Repeat this step until the calibration screen no longer displays.
Using the Intellisync Mobile Desktop Software
During installation, you had the chance to specify what PC software to
use as your PIM. If you chose the Intellisync PIM, the installation program
copied the Intellisync Mobile Desktop software to your PC. You may want
to use the Intellisync Mobile Desktop to keep track of your contacts,
memos, calendar items, etc. on your PC, and to synchronize this data
with REX.
To start the Intellisync Mobile Desktop:
•
From the Windows Start menu, select Programs / REX 6000 /
Intellisync Mobile Desktop.
For information on how to use Intellisync Mobile Desktop, select the Help
menu after starting the program.
13