How To Remove The Mower Housing; How To Install The Mower Housing - Sears 536.270212 Owner's Manual

HOW TO REMOVE THE MOWER HOUSING

1. Move the lift lever to the middle position.
2. Move the attachment clutch to the DISENGAGE position
(Figure 30).
3. Disconnect the blade drive link from the pivot rod and brack-
et assembly. See illustration "C".
4. Remove the hair pins from the adjuster plates. See illustra-
tions "A" and "B".
5. Move the mower housing to the left until the right side adjuster
plate separates from the hanger. See illustration "A".
6. Move the mower housing to the right until the left side adjuster
plate separates from the hanger. See illustration "B".
7. Remove the long pin from the front hanger. See illustration
"D".
8. Remove the mower drive belt from the stack pulley. Slide the
mower drive belt between the stack pulley and the belt
guide.
9. Completely turn the steering wheel to the right. Pull the mower
housing away from the left side of the unit.
Stack Pulley
Belt Guide
A
Adjuster Plate
Hanger
Mower Drive Belt
B
Adjuster Plate
Hanger
F–000614J
SERVICE AND ADJUSTMENT
Lift Lever
Hair Pin

HOW TO INSTALL THE MOWER HOUSING

1. Completely turn the steering wheel to the right. Push the mower
housing under the left side of the unit.
2. Slide the mower drive belt between the stack pulley and the
belt guide. Put the mower drive belt around the stack pulley.
Make sure the "V" side of the mower drive belt is against the
stack pulley. Also, make sure the mower drive belt is not
twisted.
3. Attach the mower housing to the front hanger with the long
pin. Fasten with the washer and hair pin. See illustration "D".
4. Attach the adjuster plates to the hangers with the hair pins.
See illustrations "A" and "B".
5. Connect the blade drive link to the pivot rod and bracket
assembly with the fasteners. See illustration "C".
6. Move the attachment clutch to the ENGAGE position. Make
sure the mower drive belt is inside all the belt guides.
7. Make sure the mower housing is level. See the instructions on
"How To Level The Mower Housing".
8. Check the operation of the attachment clutch. See the instruc-
tions on "How To Adjust The Attachment Clutch".
Blade Drive Link
Long Pin
Pivot Rod and
Bracket Assembly
Front Hanger
27
Attachment Clutch
Long Pin
D
C
Blade Drive Link
Figure 30