5.2 Tuning the brakes 5.3 Freewheel clutch [optional] Images front brakes Operating panel 6.1 General 6.2 Gears 6.3 the AUTO button Images operating panel Miscellaneous 7.1 Front and rear light 7.2 Walking on the Lopifit 7.3 Maintenance tips Images lights...
In case the red lights are NOTE: 1.1 Motor sensor The walking bike has an electric on and the brakes were not magnetic sensor. It registers the activated. your Lopifit won't work and you'll have to adjust the brake sensors movement of the treadmill and it [read 1.3].
In any case. a belt always drifts towards the side which case the belt will get too tight. This will influence the Lopifit's per where the belt is too loose. formance. Turning the left bolt a quater...
I mag es battery Key horizontal. Key vertical. Insert key, push Image 9: Image 10: Image 11: battery is on. battery is off. and turn to the left. Charge socket. Image 12: pull the tab. Lopifit Instruction Manual - Page 9...
B and at the same time pay the cover back on. attention to keep the bar aligned with the wheel. Again: to loosen a bolt. turn left. to tighten a bolt. turn right. Lopifit Instruction Manual - Page 10...
You can both tighten or lossen them. Before you can tune the brakes you have to disconnect the outer holder unit shown in part A [see image 17]. Push the disc until the round notch Lopifit Instruction Manual - Page 12...
6.3 The AUTO button By pressing the AUTO button. the [four lights] and your current speed treadmill starts running and the Lopifit [three lights]. If you accelerate in a moves forward. You can use this lower gear you can save battery life.
7.1 Front and rear light The Lopifit has a front and rear light. The front preselected speed. Once in motion you light has two light options; press and can proceed with step c listed under release once and the light will be flashing.
Need help?
Do you have a question about the walking bike and is the answer not in the manual?
Questions and answers