Subscribe to Our Youtube Channel
Related Manuals for Silent Gliss SG 10302
Summary of Contents for Silent Gliss SG 10302
-
Page 1: Operating Instructions
Radio hand-held transmitter SG 10302 868 MHz Operating instructions Please take care of the operating instructions! Nr. 18 122.2701/1209... -
Page 2: Table Of Contents
Contents Device explanation On front of device Device explanation ........EN- 2 868 MHz Safety instructions/exclusion of liability . -
Page 3: Safety Instructions/Exclusion Of Liability
• Use only in dry rooms. be achieved. • If one or more radio hand-held transmitters are used Silent Gliss assumes no liability for personal injuries, property for controlling the system, its operating range must damages and financial losses that arise from non-observance of stay visible during operation. -
Page 4: Scope Of Supply/Intended Use
Intended use transmitter, unlike in a bidirectional radio system. The radio hand-held transmitter SG 10302 is a multi-channel It is also not possible to pass on the radio signal from one radio transmitter. Each channel can be used unidirectionally or receiver to another. -
Page 5: Mounting Of The Wall Bracket
Safety instructions for radio operation Mounting of the wall bracket C A U T I O N ! N O T I C E ! The wall bracket has to be fixed so that the drill Observe the following safety instructions for radio holes don’t touch any electrical lines. -
Page 6: Explanation Of Functions
The selected group is controlled by a travel command. With the radio hand-held transmitters SG 10302 you can use all five radio channels to control a group. The central channel (all five channel viewing windows light up simultaneously) controls all five radio channels at the same time. -
Page 7: Programming The Transmitter
(max. 1 second). The status LED lights up briefly. The system will stop – start The radio hand-held transmitter SG 10302 is now programmed. moving again – stop and then move in the CLOSE direction. N O T I C E ! 3. -
Page 8: Approach Limit Position
Approach limit positions Intermediate positions Program intermediate position 1 P R E R E Q U I S I T E ! The radio hand-held transmitter/transmitter channel P R E R E Q U I S I T E ! has been programmed. -
Page 9: Program Intermediate Position 2
Intermediate positions Delete intermediate positions Program intermediate position 2 Delete intermediate position 1 1. Press the STOP button and also the CLOSE button. P R E R E Q U I S I T E ! 2. Hold down this button combination for approx. 3 sec. The radio hand-held transmitter/radio hand-held The status LED lights up briefly. -
Page 10: Technical Data
Delete radio hand-held transmitter/ Battery changing/cleaning/disposal technical data Battery replacement Delete radio hand-held transmitter/channel 1. Press the STOP button and also the programming button P N O T I C E ! (back of unit). • Replace batteries only with identical type 2. -
Page 11: Notes On Troubleshooting
Troubleshooting/repair Notes on troubleshooting Fault Cause Remedy The tubular motor 1. Batteries are low. 1. Replace batteries. does not run, 2. Batteries are incorrectly 2. Insert batteries the status LED installed. correctly. does not light up. The tubular motor 1. The receiver is outside 1. - Page 12 Silent Gliss International Australia Silent Gliss Pty Ltd. Phone: 0061 2 981043 00 Great Britain Silent Gliss Ltd. Phone: 0044 1843 863 571 Unit 1B/107 Carnarvon Street Fax: 0061 2 981043 11 Pyramid Business Park Fax: 0044 1843 861 226...
Need help?
Do you have a question about the SG 10302 and is the answer not in the manual?
Questions and answers