Advertisement
Quick Links
Advertisement
Summary of Contents for Neoterics BLASTER 1000
- Page 1 INSTRUCTIONS...
-
Page 2: Connect Hose
Filter Cleaner. Cleaning your dirty pool filter will now be a whole lot easier. Taking just a few minutes, the BLASTER 1000 will clean your filter by automatically rotating it while PowerJets blast focused water to clean the filter pleats. - Page 3 Add Nozzle Covers (If needed) Attach nozzle covers to close off unneeded PowerJets. This will also increase the pressure available to the remaining PowerJets. Use firm pressure to press the nozzle cover on from directly above the PowerJet nozzle. Place Filter Place your dirty filter on the center support rods as shown.
- Page 4 Add Spray Covers (If needed) Attach spray covers as needed to block the spray from coming from the area not covered by your filter. Attach the spray covers to the top outer frame tubes. Leave unused spray covers on the bottom frame tubes.
- Page 5 The Cleaning Begins BLASTER 1000 will now automatically clean your filter. The process normally takes between 3 - 8 minutes depending on how dirty your filter is. When no more debris is seen in the runoff water your filter is...
-
Page 6: Troubleshooting
(not included with the Blaster 1000). Call Neoterics for support. It is normal to observe some water escaping from around the support rods – the unit design allows for this and it will not affect the performance. -
Page 7: One-Year Limited Warranty
Should there be a defect or malfunction of this product, Neoterics will repair or replace the product, at Neoterics’ option, free of charge other than the postage required. - Page 8 INNOVATION AT WORK 119 N. Maple St., Unit S Corona, CA 92880 951-808-4744 951-808-4834 (Fax) See what’s new at… www.neoterics.com...