Advertisement
Install the VOCO App
Install VOCO Voice Controller app on your Android smart phone or tablet
("Android devices"). From your Android device, navigate to the
and search for "VOCO." Find the result labeled VOCO Voice
Controller and install the app on your Android device.
Alternatively, scan the QR code with your Android device
using a barcode scanner app.
NOTE:
Always get the latest Quick Start Guide by visiting the
downloads section at
Setup VOCO V-Zone Receiver
Plug the Power Cable into the back of the V-Zone and then plug the other end
into a power outlet. The light on the front of your V-Zone will illuminate while your
V-Zone starts up.
Now it's time to Configure Your V-Zone.
VOCO provides two (2) ways to configure and use your V-Zone.
1) via Ethernet (easiest) and 2) Wirelessly via your home Wi-Fi network.
Ethernet - Simply connect the V-Zone to your router via Ethernet cable provided.
Wait about 3 minutes and your V-Zone will be ready to use.
Wirelessly - Ensure your Android device is connected to your home W-Fi network
and within 10 feet of the V-Zone for this initial setup.
#1. After 2-3 minutes, you will see a
"New V-Zones have been discovered!" in the notification section of your
Android device. Select and tap it. If you find this then skip #2 and go to #3.
#2. If you did not find the
device and tap on it to open it. Then select Menu > Preferences > VZones.
myvoco.com.
Locate and screw in the supplied Antenna
to the back of the V-Zone. Plug one end of
the supplied Audio Cable into the "A/V"
Port on the back of the V-Zone, and the
other end into your Stereo or other audio
equipment.
icon, then locate the VOCO app on your Android
icon or a message that says
Android Market
Advertisement
