Bolting Down Your Bighorn Or Kodiak Safe - RHINO Bighorn series Owner's Manual

Safe must be bolted directly to floor with the shipping feet
removed. To remove shipping feet, please refer to page 3.
Your safe is predrilled from the factory for anchoring with 4 holes through
the floor of your safe.
1. Place safe in exact location desired.
2. Use shims to level your safe if necessary
3. Open door carefully and remove black caps to expose anchor holes.
4. Purchase anchor bolts suited for your floor type. We recommend using
a minimum of 3" long wedge anchor bolts for concrete floors that are
1/2" in diameter. For wood floors, we suggest a minimum of 2 1/2"
long lag bolts at least 3/8" in diameter. Always research your floor type
to make sure standard anchor bolts or lag bolts are adequate.
5. Follow bolt manufacturer's installation instructions.
Anchoring hardware and shims are not included.
WARNING: Your safe is heavy and presents a safety hazard unless bolted down.
You must bolt down your safe to validate your break-in warranty.
Bolting Down Your
Bighorn or Kodiak Safe
(shims not included).
4