Wipers - Saab 9001994 Owner's Manual

Hide thumbs Also See for 9001994:
Table of Contents

Advertisement

78
Car care and technical information
NOTE
In conditions other than normal driving,
Turbo models may require a different
spark plug than is fitted as standard
e9u!pment. Extensive idling, stop-and-go
driving and operation in cold climates
over
repeated
short trips without sufficient
engine warmup may cause Turbos to re-
~uire
the spark plug listed for City Driving
In
the Specification section of this book.
Discuss this
with your dealer.
If the spark plugs
are
removed, take care
that no dirt enters the cylinders. Use only
the recommended spark plug heat range.
Gap the spark plug to
specification.
Resistor-type plugs should not be used.
Ignition lead runs
S3797
Resistive wire leads are used for radio in-
terference suppression.
To remove the plugs you must first remove
~he
two screws holding the spark plug cover
In
place and remove the cover. On all en-
gines remove the plug wires by gripping the
protective boot
with
special boot removal
pliers to prevent damage to the
wire.
Never
pull directly on the wire. Install spark plugs
carefully to avoid damage to the threads in
the
~Iuminum
cyli.nder head.
The
firing or-
der
IS
1-3-4-2
(cylinder number 1 is closest
to the firewall).
Wipers
Inspect and clean the rubber blades of the
win~shield
at regular
intervals.
Methyl
alco-
hol
IS
recommended for cleaning. If the
blades show signs of
wear,
they should be
replaced. For best windshield wiper perfor-
mance the glass must be free of wax and
oily road
grime.
Changing the windshield wiper
blades
Lift the wiper arm away from the windshield.
Depress the plastic clip (1) and slide the
complete wiper blade assembly out
of
the
loop at the end of the wiper arm (2).
Free the blade rubber from the
retainer
(see
illustration) by pressing together the two
shiny metal pieces and twisting the rubber
to
disengage the retainer
from
the recess
in the blade. The rubber
can
now be with-
drawn through the other retainers. To fit the
rubber,
slide it through the four retainers
and then
tighten
it so that the retainer at one
end engages the recess
in
the blade rub-
ber.
Complete
replacement blade assemblies
are also available from your Saab dealer.
Changing
a
windshield
wiper blade

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents