Instructions For Use; Check The Package Contents; Charging Your Tablet; Rechargeable Lithium-Ion Battery - Newland NQuire Tough Tab 8 User Manual

Instructions for use.

Check the package contents.

The package contains:
• 1 x NQuire Tough Tab 8 Tablet
• 1 x Power Supply Unit with Mains Plug
Adaptor
• 1 x USB OTG Cable
• 1 x User Guide
• 1 x Hand Strap Panel (pre-assembled on
Rotating Hand Strap Panel) (Optional)

Charging your tablet.

Your battery has been partially charged at the
factory, but you may need to recharge it before
you can switch the tablet on for the first time.
Note: It is recommended to recharge the battery
of the tablet fully before turning on for the first
time.
Important: Use only the provided or
approved chargers or cables with this tablet.
1. Plug the charger into a wall outlet
2. Connect the mains charger to your tablet via
the connector on the charger. The Power indicator
LED will light up when charging.
When the battery is full, disconnect the charger
from the tablet, then from the wall outlet.
Note: To check the current charge level of the
battery, press the icon located at the bottom
right of the screen.
Note: You don't need to charge the tablet for
specific length of time, and you can use the tablet
while it is charging.
Note: If the battery is completely discharged, it
may take several minutes before the tablet can
be used.

Rechargeable Lithium-Ion battery

Your tablet has an internal Lithium-ion polymer
battery which should last the lifetime of the
product.
If you suspect that the battery is dead, try
charging it several times and follow the steps for
charging your tablet.
• Do NOT attempt to change the battery
yourself.
• CAUTION: Danger of explosion if batteries are
incorrectly replaced.
• NEVER use or charge the battery if it appears
to be leaking, discoloured, deformed or in any
way abnormal.
• NEVER expose the battery to any liquid.
• NEVER expose the battery to excessive heat
such as direct sunlight or fire.
• NEVER throw batteries in a fire or attempt to
open the outer casing.
• Batteries are harmful if swallowed, so keep
away from and out of reach of infants and
young children.

Using your tablet.

Turning your tablet On

To turn your tablet on, press and hold the Power/
Sleep button and the tablet will begin to power up.

Putting your tablet into Sleep mode

To put your tablet into Sleep mode, press the
Power/Sleep button once. The screen should
switch off and your tablet will be in Sleep mode.
To wake the tablet from Sleep mode, press the
Power/Sleep button once. The screen should
wake up and display the lock-screen.
8

Turning your tablet Off

To turn your tablet off, press and hold the Power/
Sleep button until you are prompted with the
'Slide to shut down your PC' message. Slide and
drag your finger down the screen to begin the
shut down process and turn off your tablet.

Emergency reboot

To reboot your tablet if the screen becomes
unresponsive, press and hold the Power/Sleep
button for 10 seconds until the screen turns off.
Note: Leave the tablet for 15 seconds before
trying to reboot the tablet.
Important: Avoid powering the tablet down
by using the emergency reboot where possible.
Always try to shut down your tablet using the
correct shut down method to avoid loss or
damage to data.

Increasing and decreasing the volume

To increase the volume level on your device,
press the Volume up button. Repeatedly press
the Volume up button until the desired volume is
reached.
To decrease the volume level on your device,
press the Volume down button. Repeatedly press
the Volume down button until the desired volume
is reached.

Using headphones with your tablet

You can connect headphones with a 3.5mm plug
(not included) to your tablet. The headphone
socket can be found on the bottom of the device
highlighted with . When you have headphones
connected the tablet speaker is switched off and
all sound is via the headphones.

Installing a Micro SD card

Your tablet supports Micro SD cards (not included)
for additional storage of data and files.
Important: Use only compatible memory
cards approved for use with this device.
Incompatible cards may damage both the memory
card and the tablet and may corrupt data stored
on the card.
To install a Micro SD memory card:
1. Locate the Micro SD card slot on the tablet.
2. Insert the Micro SD card into the slot with
the gold contacts facing up, carefully slide the
memory card into the slot, pushing gently until it
clicks into place.
Note: To remove a memory card, push the
memory card gently until it clicks and the spring
will push the card out to allow you to remove it
from the tablet.
Important: Do not remove a memory card
when files are currently being used by the tablet.
This may corrupt or lose the data stored on the
memory card.

Installing a Micro SIM Card

Your tablet supports Micro SIM cards for 3G
connectivity (where available).
Important: 3G Ready Micro SIM cards and
data plans are sold separately and may be subject
to additional contracts and fees. Contact your
network operator for advice regarding connectivity
or network charges.
Important: Please ensure that your tablet
is turned off before installing or removing a Micro
SIM card.
To install a Micro SIM card:
1. Locate the Micro SIM card slot on the tablet.
2. Insert the Micro SIM card into the slot facing
9