With The Rear Axle Raised - Mercedes-Benz 2013 W218 Owner's Manual

The mountings for the removable towing eyes
are located in the bumpers. They are at the
front and at the rear, under the covers.
X
Remove the towing eye from the vehicle
tool kit ( Y page 353).
X
Pull cover : out of the bumper in the
direction of the arrow by inserting your fin-
gers into the recess.
X
Press the mark on cover ; inwards in the
direction of the arrow.
X
Remove cover ; from the opening.
X
Screw the towing eye in clockwise to the
stop and tighten it.
Removing the towing eye
X
Loosen the towing eye and unscrew it.
X
Position the top of cover : in the bumper
and press it in at the bottom until it
engages.
X
Attach cover ; to the bumper and press
until it engages.
X
Place the towing eye in the vehicle tool kit.
Towing the vehicle with the rear axle
raised
! The ignition must be switched off if you
are towing the vehicle with the rear axle
raised. Intervention by ESP
wise damage the brake system.
Only possible on vehicles without
4MATIC.
X
Switch on the hazard warning lamps
( Y page 124).
X
Turn the key in the ignition lock to position
0 and remove the key from the ignition
lock.
X
When leaving the vehicle, take the key or
the KEYLESS-GO key with you.
When towing your vehicle with the rear axle
raised, it is important that you observe the
safety instructions ( Y
®
could other-
page 365).
Towing and tow-starting
Towing the vehicle with both axles on
the ground
It is important that you observe the safety
instructions when towing away your vehicle
( Y page 365).
The automatic transmission automatically
shifts to position P when you open the driver's
or front-passenger door or when you remove
the key from the ignition lock. In order to
ensure that the automatic transmission stays
in position N when towing the vehicle, you
must observe the following points:
X
Make sure that the vehicle is stationary and
that the key is in position 0 in the ignition
lock.
X
Turn the key to position 2 in the ignition
lock.
On vehicles with KEYLESS-GO, use the key
instead of the Start/Stop button
( Y page 157).
X
Depress and hold the brake pedal.
X
Shift the automatic transmission to posi-
tion N.
X
Release the brake pedal.
X
Release the parking brake.
X
Switch on the hazard warning lamps
( Y page 124).
X
Leave the key in position 2 in the ignition
lock.
i When towing with the hazard warning
lamps switched on, use the combination
switch as usual to signal a change of direc-
tion. In this case, only the turn signals for
the desired direction flash. When you reset
the combination switch, the hazard warn-
ing lamps start flashing again.
Transporting the vehicle
! Only lash the vehicle down by the wheels
or wheel rims, not by parts of the vehicle
such as axle or steering components. Oth-
erwise, the vehicle could be damaged.
367
Z