Table of Contents
Advertisement
Quick Links
Installation, Operation and
Maintenance Manual
ScaleSolver Systems
TM
Chemical Free, Salt Free, Scale Prevention
Model: SS-2025 3/4"
523 South Fair Oaks
Pasadena, CA 91105
(800) 334-5009
LifeSourceWater.com
©2013 LifeSource Water Systems, Inc.
Contactor's Lic. CA #787179 NV #059578
Version 10.17.2013
Advertisement
Table of Contents
Summary of Contents for ScaleSolver 97SLP
- Page 1 Installation, Operation and Maintenance Manual ScaleSolver Systems Chemical Free, Salt Free, Scale Prevention Model: SS-2025 3/4” 523 South Fair Oaks Pasadena, CA 91105 (800) 334-5009 LifeSourceWater.com ©2013 LifeSource Water Systems, Inc. Contactor’s Lic. CA #787179 NV #059578 Version 10.17.2013...
-
Page 2: Table Of Contents
Installation, Operation and Maintenance Manual ScaleSolver SS-2025 TABLE OF CONTENTS Introduction ....................... 3 ScaleSolver Speci cations ................4 Cautions ......................5 Notes to the Installer ..................5 Installing the System ..................6 Replacing PowerTAC™ Cartridge ..............7 Note to the Homeowner ................... 8 Good Practices .................... -
Page 3: Introduction
The LifeSource ScaleSolver™ provides protection from scale formation throughout the home. The ScaleSolver™ can be installed at the point of entry to treat your entire home, both hot and cold water, or it can be located directly before a water heater or other device (e.g. sauna, etc) that requires protec- tion from hard water. -
Page 4: Scalesolver Speci Cations Tm
SS-2025 EQUIPMENT SPECIFICATIONS The ScaleSolver™ SSC-2025 is complete, self-contained, loaded with media and ready to use. A simple inlet and outlet connection is all that is required for installation. Please review operating pressures, temperatures and water chemistry limitations to ensure compatibility. -
Page 5: Cautions
flux listed under the ASTM B813 standard. Once the plumbing connec- tions are complete, place the ScaleSolver™ in bypass prior to following the startup procedure and ush the plumbing for at least 10 minutes. -
Page 6: Installing The System
• The ScaleSolver™ must be installed upstream of all equipment using hot water. • The cold water supply should only be connect to the inlet port on the ScaleSolver™ housing head. The conditioned water should only be connected to the housing outlet port on the ScaleSolver™... -
Page 7: Replacing Powertac™ Cartridge
ScaleSolver SS-2025 INSTALLING OR REPLACING POWERTAC CARTRIDGE ™ NOTE: Remove the plastic wrap from the PowerTAC™ cartridge before use. Make sure the end seal gasket is in place on both ends of the PowerTAC™ cartridge and not retained in the packaging. -
Page 8: Note To The Homeowner
ScaleSolver SS-2025 A NOTE TO THE HOMEOWNER Your ScaleSolver™ will improve the properties of water throughout your home. Here are some things to expect and some recommendations for maximizing the bene ts and your enjoyment of ScaleSolver™ . Sinks and fixtures - reduced spotting. If water is allowed to evaporate off a surface, small spots may be left behind. -
Page 9: Good Practices
We also recommend that you drain your water heater tank. This should be done 30 to 60 days after ScaleSolver™ is installed and again in one year. This is a good practice that can dramatically increase the life of your water heating appliance. If you have an electric “tank type” water heater, for optimum results and higher ef ciency, we recommend you change the heating elements to a “low watt density”... -
Page 10: Warranty
The Head is warranted to be free of defects in materials and workmanship for ve years from date of original installation. • The ScaleSolver™ PowerTAC™ media is warranted for performance for a period of three years from the date of the original installation. CONDITIONS 1. -
Page 11: Warranty Registration
SS-2025 WARRANTY REGISTRATION We appreciate your purchase of the chemical-free ScaleSolver™, scale control system. Under proper conditions you will have years of trouble-free performance from this product. The laws of the United States do not require consumers to return warranty cards or registration cards to be covered by an implied warranty, however, you must keep a copy of your receipt.
Need help?
Do you have a question about the 97SLP and is the answer not in the manual?
Questions and answers