Clearaudio Smart Phono Headphone V2 User Manual page 5

Smart Phono V2
Bedienungsanleitung
User manual
English
Smart Phono V2 / Smart Phono Headphone (H) V2
Congratulations on the purchase of your new
Smart Phono V2 / Smart Phono H V2
MC/MM phonostage. The features a power switch: we
recommend that you keep the unit switched on in order to maintain a constant temperature for
the electronic parts inside (this uses very little power).
Smart Phono V2 /Smart Phono H V2
The new also has a built-in volume control.
- Set up –
Smart Phono V2 / Smart Phono H V2.
Connect the ground of the turntable/tonearm to the
Smart Phono V2 /
To select either the MC (moving coil) or MM (moving magnet) mode of the
Smart Phono H V2
according to your cartridge type, simply use the switches on the bottom side
(one each for left and right channels):
Position MM = button not pressed, Position MC = button pressed in.
MM Adjustment MC Adjustment
Pic. 1: Adjustment MM / MC
Smart Phono V2 / Smart Phono H V2
Now you can proceed with connecting the to your MC/MM
cartridge and preamplifier. The input impedance (input load resistor / capacitance) can be
adjusted according to the cartridge requirements, using the jumpers on the bottom of the unit.
Finally, connect the power supply to the mains. For disconnecting, please follow these instructions
in reverse order.
- Attention –
Smart Phono V2 / Smart Phono "H" V2
Never cover or put anything on top of the as this could
lead to overheating of electronic parts.
If the unit is not in use for some time, please switch it off using the power switch on top of the
device. Disconnect the device completely from the power supply by removing the mains plug from
the socket.
Pic. 2: Standby mode
Seite 5 / page 5