Replacing The Starter Rope And Rewind Spring - Stihl MS 200 T Instruction Manual

N Pull off the spark plug boot.
N Unscrew the spark plug.
Checking the spark plug
N Clean dirty spark plug.
N Check electrode gap (A) and
readjust if necessary – see
"Specifications".
N
Rectify the problems which have
caused fouling of the spark plug.
Possible causes are:
– Too much oil in fuel mix.
– Dirty air filter.
– Unfavorable running conditions.
MS 200 T
If the spark plug comes with a
detachable adapter nut (1), screw
the adapter onto the thread and
tighten it down firmly to reduce
the risk of arcing and fire.
Installing the spark plug
N Install the spark plug and connect
the spark plug boot (press it down
firmly) – reassembly all other parts
in the reverse sequence.
A
Replacing the Starter Rope
and Rewind Spring
1
Replacing the starter rope
1
1
N Take out the screws (1).
N Ease the fan housing away from the
crankcase and remove it sideways.
N Use a screwdriver or suitable pliers
to remove the spring clip (2) from
the starter post.
N Carefully remove the rope rotor with
washer (3) and pawl (4).
The rewind spring may pop out
and uncoil during this operation –
take care to avoid the risk of
injury.
English
1
1
25