Rampage ACC-30 Installation Manual

Audiovox rampage 6-disc cd changer
Hide thumbs Also See for ACC-30:

Advertisement

Quick Links

6
ACC-30
DIGITAL AUDIO 6 DISC
COMPACT DISC CHANGER
MODEL ACC-30
6-DISC CD CHANGER
INSTALLATION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ACC-30 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Rampage ACC-30

  • Page 1 ACC-30 DIGITAL AUDIO 6 DISC COMPACT DISC CHANGER MODEL ACC-30 6-DISC CD CHANGER INSTALLATION MANUAL...
  • Page 2: Packing List

    Mounting Bracket 2 pcs. Mounting Angle Adjustment Tool 1 pc. ACCESSORIES CD Magazine 1 pc. Changer ACC-30 DIGITAL AUDIO 6 DISC COMPACT DISC CHANGER Hex Head Bolt with Washer Base (M5 x 12) 4 pcs. Screw Hole Cover Labels 1 pc.
  • Page 3: Before Installing The Unit

    BEFORE INSTALLING THE UNIT Transport Lock Screws The mechanism in the CD changer is "locked" into place during shipment by the 4 transport screws. Be sure to remove the screws prior to installation. Retain these screws for future use when transporting the unit for service/maintenance. After removing the transport lock screws, place the supplied seals over the screw holes.
  • Page 4: Installation

    INSTALLATION The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.
  • Page 5 PROCEDURE FOR VERTICAL INSTALLATION Note If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 3), start with step 2. Set the anti-vibration springs to position "V". position "V" Determine the mounting location, and drill four mounting holes.
  • Page 6 PROCEDURE FOR 45° ANGLE INSTALLATION Note If the anti-vibration spring position has been changed and verified for 45° angle mounting (as shown on page 3), start with step 2. Set the anti-vibration springs to position "45°". position "45°" 45° Determine the mounting location, and drill four mounting holes.
  • Page 7 WIRING Mating 8-pin DIN socket on rear of compatible radio chassis (see Note below). NOTE: 1. Check with your Rampage/Audiovox audio dealer Car Stereo with CD Changer Controls to be sure your stereo is directly compatible with this CD changer.
  • Page 8 © 1999 Audiovox Corporation, Happauge, N.Y. 11788 Printed in Korea 128-5572...

Table of Contents

Save PDF