Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for CELLKIT 909 series
- Page 1 USER GUIDE FOR : 909 Series...
-
Page 2: Package List
Thank you for purchasing the CELLKIT 909 series SMD Rework Soldering station. Please read this manual before operating this repair tools. Store the manual in a safe, easily accessible place for future reference. This CELLKIT 909 series is combination of 850 series, 936 series and DC Power Supply. - Page 3 You must shut off the power when: The temperature protector is in trouble You don't want to continue the work You want to leave the station. Be careful. It is high temperature. Never use this rework station when it is close to flammable gas or other material like paper.
- Page 4 Afet the power is switched on, the gun will blow air and the heating material will start heating. 3. Adjust the air-blow and the switch of the temperature control (see: Temperature Chart) We suggest to adjust the temperature between 250-350°C. When the indicator flicks, it means the temperature has reached the set.
-
Page 5: Temperature Chart
4. Heating Unit Demonstration fig. 2 fig. 1 5. Temperature Chart: Classification of measurement: (A1124) 3 mm to the air - blow no is measured by a recorder. The room temperature is 23°C. The diameter of A1124 single tube is 2.5 (0.09 inch) Note: 1, 4, 6, 8 : the air-blow... - Page 6 To prevent damage to the unit and ensure a safe working environment, be sure to comply with the following precautions. Do not use the unit for applications other than soldering. Do not rap the soldering iron against the work bench to shake off residual solder, or otherwise subject the iron to severe shocks.
-
Page 7: Maintenance
3. Inspect and Clean the Tip 1. Set the temperature to 250°C (482°F) 2. When the temperature stabilizes, clean the tip with the cleaning sponge and check the condition of the tip. 3. If there is black oxide on the solder-plated portion of the tip, apply new solder (containing flux and wipe the tip on the cleaning sponge. -
Page 8: Specification
Specification* Hot air soldering station Specification Specified voltage 220V/AC Consumption 270W Type of pump Membran Air flow 0.3-24L/min. Dapat diatur pump power Heater 250W logam Hot air temp. 100-420 C. Soldering station Specification Power Output Voltage 24V / AC Temp. Range 200-480 C. - Page 9 TIPS 900M-T-LB 900M-T-0.8D RO.5 (0.08) 25 (0.98) 17 (0.68) -10 C/-18 F 0.6 (0.024) 900M-T-0.5C 900M-T-1.2D 17 (0.68) 15 (0.6) 0.7 (0.028) 900M-T-0.8C 900M-T-1.6D (0.1) 17 (0.68) 17 (0.68) -10 C/-18 F 0.5 (0.02) 900M-T-1C 900M-T-2.4D 900M-T-1CF (0.2) 15 (0.6) 17 (0.68) 0.5 (0.02) 900M-T-3.2D...
-
Page 10: Power Supply
ULTRASONIC BLOWER SOLDER CS-30 CLEANER HOT AIR GUN PLIER & REPAIRING REPAIRING WORKING LAMP SCREWDRIVER TWEEZER BOARD SET MATERIALS BLOWER POWER SUPPLY SOLDER 936 INFRA RED...