Table of Contents
Advertisement
3. Install Window Hller
1. Measure distance "X" between
the face of the window stop molding
and the side of the cabinet.
of
\
Side of Cabinet
2. Subtract one groove (3/16") from
the "X" measurement to obtain the
required width. Using a sharp knife,
mark the groove until the filler panel
becomes weak enough to break
apart.
'X" Minus One Groove (3/16")
Filler ~anel
3. Insert the cut edge of the filler
panel into the cabinet side seal
groove (position 1). Leave a small
space at the bottom of the cabinet
side seal groove.
Cabinet Side Seal
\
Rotate the filler panel backward
toward the window frame until the
filler panel clears the window
stool. Push the filler panel down
against the window sill.
I
Position 3 Position 2
I
Slide the filler panel out from the
air conditioner cabinet until the
I
filler panel flange contacts the
window stop molding (position 3).
4. Attach the filler panel to the
face of the window ~top molding by
driving upholsterers' tacks through
the holes in the filler panel flange.
Upholsterers'
Tack =
1! I
5. Pull the sliders out until the
sliders contact the face of the
window stop molding.
Hole in Slider
Cabinet
I
,
.
Holes in
I
Window Stol
Molding
II
9
6. Pull the bottom window sash
down tightly and lock it in place by
installing a ~pe A screw through
the hole in the slider into the
window sash.
4. Sfide-sis into Cabinet.
1.
Slide the chassis into the cabinet
and insert the line cord into the
notch in the cabinet. Make sure the
front of the chassis is flush with the
front of the cabinet.
2. Cut the plastic foam seal to the
proper length and insert it between
the upper and lower window sash.
5. Attach Dial Plate and
Control mobs.
6. At@ch Air~lter and
front Grille.
See page 5.
(continued next page)
Cord
Advertisement
Table of Contents
