Advertisement
.fiWt.fie as jt(
I. Remove Plastic Shipping Caps from Generator Components. Assemble Generator Components as
illustrated
below, EXCEPT the *STAMPED NUT (5/8-18). See Note I
2. You will need to work where the Vehicle Speedometer Cable is attached to the Transmission. If
necessary. raise the vehicle. Chock Wheels.
,B~not
get ~d~,r,~Yvehicle
held~p
by.ajacko,~~-,Us~Jack
Stands or Ramps-,
":l:JI;eweb,9£,,a,~9~c~~teblockWiU
,n9{
car-,,'I)ONOT,RISK,YOUR
LIFE! "
" ,
"'"", ' ,I""",
",I" ""
'
" '
" ,
3.
A. Disconnect
Vehicle Speedometer
Cable from Transmission.
B. Connect Speedometer Cable to TANG DRIVE ADAPTER. Seat Speedometer Cable into
TANG DRIVE ADAPTER Slot, tighten Speedometer Cable. See Note .I
c. Install Generator Assembly into transmission housing. Turn SIGNAL GENERATOR so wires
will not catch on objects while driving. Tighten Nut.
TO
EXISTING
SPEEDOMETER
CABLE
-
NOTE
.I
After Cable is assembled, inserlADApTERKEYintoother
end and rotate Drive Cable. If Cable will not rotate,
remove TANGDRIVEADAP:TER andinsta11*STD
NUT
(5/8-18) in position
shown. Reinstall
TANG])iu\iE ADAPTER.
This will allow clearance betWeen Speedometer
Drive
Cable Inner Core Wire and SIGNAL GENERATOR Assembly.
Form# 2097
6199 Rev B
Advertisement
