Programming Your Remote; Digital Adapter Troubleshooting - Wow Atlas Reference Manual

Step E: Activating your Digital Adapter
Once you have connected your Digital Adapter(s), they are ready to be
activated, which will authorize your Digital Adapter(s) to begin receiving
signals from WOW!'s network and send cable channels to your TV. Once your
Digital Adapter(s) are activated you will be able to enjoy your WOW! Cable.
All Digital Adapter's must be connected prior to activation.
To activate your Digital Adapter(s), visit www.wowdigitaladapter.com or call
1-888-268-5872.

Programming Your Remote

Program your remote to sync with your TV model.
1. Get remote instructions manual from self-install kit. Find the brand name and 3-digit
device code number of your TV. For example, Panasonic TV: 005, 006, 007, 008.
2. Manually turn on the TV.
3. Confirm the batteries are correctly inserted in the remote.
4. Press and hold the "Set" button. Then, while holding down "Set", press
the Power button. The LED light will turn red, indicating the remote is in
program mode. Release both buttons.
5. Enter the 3-digit Device Code (for example: code 005 under Panasonic TV). The
red LED light turns off if the code has been accepted by the remote control.
6. If the LED light flashes twice, it means the code entered is incorrect, and
the remote control remains in program mode. Re-enter the correct code
number again. The remote will exit program mode if the code is not entered
within 10 seconds.
7. Point the remote towards the TV and press the Power button. If the TV
turns off, the remote is now programmed to operate the TV.
8. If the TV fails to turn off, go back to Step 1 and enter the next code listed
under the TV brand.

Digital Adapter Troubleshooting

How do I program my VCR to record using a WOW! Digital Adapter?
To record a program using your Digital Adapter and VCR:
1. Set your VCR to record channel 3 (4 in Cleveland) for the time the program
is airing.
2. Tune the Digital Adapter to the channel you want to record.
The VCR can only record the channel that your Digital Adapter is tuned to.
To record different programs at different times, you will need to change the
channel on your Digital Adapter.
My Digital Adapter takes too long to change the channels. What can you
do about that?
We understand that the experience may be different from what you are
used to. Unfortunately, there may be a slight delay when you are changing
channels as the Adapter works to tune from one digital signal to the next.
My Digital Adapter remote stopped working, loses its programming or
won't power off/on.
If your remote loses its programmed codes, try replacing the batteries with
high quality Alkaline batteries. When replacing the batteries, try not to push
any buttons, and the codes should remain intact.
For a list of Frequently Asked Questions, visit wowway.com.
E-34