Should it be necessary, the stop can be released by turning the ratchet wheel at the back of the tool in the direction indicated by the two yellow arrows. Keep the movable handle under light pressure during this operation. Instruction manual HT250 www.foehrenbach.be Date : August 2007 Documentrev.
Note: 1) The terminal positioner may not damage the insulation barrel or wire barrel of terminal. 2) This adjustment may affect the bellmouth of the terminal. Instruction manual HT250 www.foehrenbach.be Date : August 2007 Documentrev. : 6 Page : 4 / 11...
- Apply the tool only for the purpose as mentioned in chapter 1. - Apply the tool only in a dry and well illuminated environment (1000 lux). - Apply always a correct eye protection. Instruction manual HT250 www.foehrenbach.be Date : August 2007 Documentrev.
Page 6
Figure 1 Instruction manual HT250 www.foehrenbach.be Date : August 2007 Documentrev. : 6 Page : 6 / 11...
Hex nut M6 Din 934 191609 Compression spring No 59 5305-035-003 Waher 6,0 Din 1440 191610 Special nut M6 5305-003-008 But. hd. cap screw M4 x 12 Instruction manual HT250 www.foehrenbach.be Date : August 2007 Documentrev. : 6 Page : 7 / 11...
Page 8
Socket set screw M4x20 180983 Stop bushing 180984 Distance plate 190115 Key for crimp height adjustment 190116 Upper pin wrench 2 mm 190117 Pin wrench 2.5 mm Instruction manual HT250 www.foehrenbach.be Date : August 2007 Documentrev. : 6 Page : 8 / 11...
Page 9
Figure 2 Instruction manual HT250 www.foehrenbach.be Date : August 2007 Documentrev. : 6 Page : 9 / 11...
The technical data in this publication has been carefully checked and assembled. No liability from inaccuracies or errors is assumed. The right to change or improve this document without notice is reserved. Instruction manual HT250 www.foehrenbach.be Date : August 2007 Documentrev.
CERTIFICATE OF CONFORMITY We hereby certify that the hand tool HT250 described below has been manufactured and inspected, and is conform to applicable drawings, requirements and specifications, according to FCI spec TA-317. Serial number of hand tool: ……………………….. Specification: • Wire range AWG 22-24: 0.22 - 0.33 mm²...