Verify The Conductor Pinpointed - Pipehorn Series 800-H User Manual

Verify the Conductor Pinpointed

Mark the spot where you have pinpointed the line and check the
direction by twisting the Receiver left and right to get the strong-
est signal.
Now place the Transmitter on the mark, in-line with the conduc-
tor, and trace the conductor back to its source.
Trace the Conductor's Path
When satisfied that you've found the target conductor, begin
walking away from the Transmitter, tracing the path of the con-
ductor by sweeping the antenna left and right. Always keep the
antenna level and listen for the LOW-HIGH-LOW sound change.
Trace as far as necessary adjusting the sensitivity control to
maintain a solid, non-beeping tone.
Weak or Confusing Signal
When the sensitivity control is fully clock-wise or the tone be-
comes jittery or unclear, reposition the Transmitter at the last
clear location and continue tracing.
14