Omega National 90026WHI1 Installation Instructions Manual

RANGAIRE LP
Division of Broan-NuTone LLC
The Power Module
90026WHI1
Before you begin, read the following instruc-
tions completely and carefully. If followed, they
will simplify the installation.
IMPORTANT: OBSERVE ALL GOVERNING
CODES AND ORDINANCES
SAVE THESE INSTRUCTIONS FOR THE
LOCAL ELECTRICAL INSPECTOR'S USE
I NTENDED FOR DOMESTIC COOKING ONLY
W
ARNING!!
FIRE, ELECTRICAL SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
this unit only in the manner intended by the manufacturer. If you
have questions, contact the manufacturer. Before installation
and before servicing or cleaning unit, switch off power at ser-
vice panel and lock service panel to prevent power from being
switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent device,
such as a tag, to the service panel.
Installation work and electrical wiring must be done by quali-
fied person(s) in accordance with the National Electrical Code
and all applicable codes and standards, including fire rated
Form OME-004 02/06 628019A
Owner's
INSTALLATION INSTRUCTIONS and PARTS LIST
INSTALLATION INSTRUCTIONS
Read and Save These Instructions
TO REDUCE THE RISK OF
Omega National Products, LLC
Guide
CARE OF FILTER-
type aluminum foil filter should be removed and cleaned periodically.
To clean, the filter should be soaked in hot water and detergent, then
thoroughly rinsed.
CARE OF EXTERIOR SURFACE
a beautifully finished addition to your kitchen. Clean with a mild deter-
gent to reserve its lasting beauty.
DO NOT
90026WHI1
construction. When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities. Use only
metal ductwork or ducted fans, routed to the outdoors.
Use with approved cord connection kit only.
ELECTRICAL GROUNDING - Permanently ground this
unit in accordance with the latest National Electrical Code and
applicable local codes and ordinances.
A permanent ground connection should be made to the unit
using a conductor of appropriate size from a grounded continu-
ous metallic cold water pipe, a grounded lead in the service
panel, or a properly driven and electrically grounded ground
rod. Do not ground to a gas supply pipe.
W
Use
ARNING!! Sufficient air is needed for proper combus-
tion and exhausting of gases through the flue (chim-
ney) of fuel burning equipment to prevent back draft-
ing. Follow the heating equipment manufacturer's guidelines
and safety standards such as those published by the National
Fire Protection Association (NFPA), and the American Society
for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
C
AUTION!! For general ventilating use only. Do not
use to exhaust hazardous or explosive materials and
vapors.
Page 1
Distributor
For greatest efficiency the permanent
use abrasive cleansers.
©2006 Omega National Products, LLC.
- Your Exhaust Unit is