Medisana SAC Manual page 17

Sunrise alarm clock
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 15
2.2
Positioning
and setup
2.3
Button functions
WARNING
Please ensure that polybag packing is kept away from reach
of children! Risk of suffocation!
1. Place the device on a solid and flat surface for use to ensure that it cannot
tip over or fall down.
2. Position the device about 40 - 50 cm away from your head, for example, on
a bedside table.
3. Connect the power supply to the power point.
NOTES
Your MEDISANA Sunrise Alarm Clock SAC is equipped with R.D.S. (Radio
Data System). The device receives its time information via the R.D.S. signal.
If no R.D.S. signal is available, the time is not set automatically.
The abbreviation of the radio station is displayed in letters. If the radio
station does not send a signature, only the digital frequency of the radio
station is displayed.
The time
(12:00)
in the display
ing TIME SETTING appear on the display to the automatic time setting. After a
few minutes, the current time is accepted and displayed on the display. The
text SET SUCCESS runs through the bottom of the display. If the radio signal
of the R.D.S. sender is not received, the R.D.S. icon disappears after about 60
seconds and the text SET FAIL appears. In this case you set the time manually
using the
Set button
Setting the time and the alarms manually
Press the Set button
flashes every 0.5 seconds. You can now set the time manually.
Press the buttons
the time and get to your settings for alarm 1 (AL1) / alarm 2 (AL2) / Zizz (short-
time alarm).
Use the buttons
your selection with the Set button
time by pressing the buttons
the AL1 icon and alarm time flash every 0.5 seconds. Confirm the set alarm
time with the Set button
immediately afterwards. The radio (FM) or sound icon appears on the display.
starts blinking, the R.D.S icon and the writ-
and the buttons
for about 3 seconds; the time on the display
or
. Press the Set button
or
to choose the desired alarm and confirm
(take AL1 for example). Set the alarm
or
. Whilst you are setting the alarm,
. The selection menu for the chosen alarm appears
2 Operation
.
and
again to confirm
GB
11

Advertisement

Table of Contents
loading

Table of Contents