Related Manuals for J&M Corporation STAGE-4 ROKKER XXR XXRK-630SP4-15RU-CVO
Summary of Contents for J&M Corporation STAGE-4 ROKKER XXR XXRK-630SP4-15RU-CVO
- Page 1 J&M STAGE-4 ROKKER® XXR Custom 630w 4-Speaker/ Amplifier Installation Kit for 2015-17 Harley® Roadglide Ultra CVO XXRK-630SP4-15RU-CVO Installation Instructions...
-
Page 2: Product Overview
Product Overview Fig. A This is the new J&M STAGE-4 ROKKER® XXR Custom 630w 4-speak- er/amplifier installation kit for your 2015-2017 Harley Roadglide Ultra CVO (ONLY) with the Harley 6.5GT Premium CVO radio. At the very heart of this system is our in-fairing mounted 4 channel ROKKER XXRP amplifier rated @ 157.5w RMS per channel X 4 to provide up to 630w total RMS power! The amplifier will be custom tuned for use in conjunction with your... - Page 3 Rear Trunk-pod Speaker Installation Fig. A 1. Remove both of the stock Harley rear trunk-pod speakers. (Figure A) 2. Identify the ROKKER XXR speaker/grill assembly for the left side, plug-in the wire spades and install complete assembly oriented as per the diagram. (Figure A) 3.
-
Page 4: Amplifier Installation
Amplifier Installation Fig. A 1. Remove the windshield, outer fairing shell, seat, and fuel tank. 2. By following along the factory wiring harness, route the amplifier power harness from the fairing, under the fuel tank, and on to the battery. (Removal of the fuel tank is necessary for proper installation) 3. - Page 5 9. Connect the amplifier main wiring harness to the amp before Fig. C securing to the mounting bracket. Center the amp into position, place top bracket with J&M Logo facing up, align the screw holes and insert the four supplied screws and tighten securely. 10.
-
Page 6: Specifications
Specifications ROKKER® XXRP 630 Full Range Class D Amplifier S/NRatio Output Power (RMS) @ 1% THD 1000Hz 14.4V CEA 2006 Separation >90dB >74dB Stereo @ 4ohms 4 x 157.5 Watts – 630w RMS Total Stereo @ 2ohms 4 x 157.5 Watts – 630w RMS Total Input Sensitivity .35V - 3.9V Frequency Response -3dB... -
Page 7: Warranty Registration Form
WARRANTY AND REPAIR INFORMATION TWO YEAR LIMITED WARRANTY In order to facilitate the servicing of this warranty, the Warranty Registration Form should be filled out and returned within 10 days of the date of purchase. However, return of the Warranty Registration Form is not a precondition of this warranty, and this Warranty will be observed by J&M CORPORATION whether or not the Warranty Registration Form is returned, on the condition that other satisfactory evidence of the date of the original purchase is provided to J&M CORPORATION.